Info

The hedgehog was engaged in a fight with

Read More
Q&A

Can I use a circular saw instead of a miter saw?

Can I use a circular saw instead of a miter saw?

With enough experience and technical knowledge, a circular saw can be used to make any kind of cuts that you can think of. It can even make miter and bevel cuts that you would normally have to use a miter saw for. A miter saw, on the other hand, is a specialty tool.

How do I make an accurate cut with a circular saw?

How to Make Perfect Cuts With Circular and Miter Saws

  1. Tip 1: Let Cutoffs Drop Free to Avoid Binding the Blade.
  2. Tip 2: Clamp Your Work for Precise Bevel Cuts.
  3. Tip 3: Make Plunge Cuts Safely.
  4. Tip 4: Replace That Dull Blade.
  5. Tip 5: Clamp Short Pieces in the “No Hands” Zone.
  6. Tip 6: Cut Small Pieces Safely.

Is a circular saw worth it?

It has versatility and portability. For your DIY work, it should be one of the best hand tools you should consider. Also, if you are a professional tradesperson, you need the tool. With a circular saw, you can cut plywood for your needs including for roof or bookcase or lumber for framing, you can cut them with ease.

Can you turn a circular saw into a miter saw?

We have seen circular saws used as table saw replacements with the Eurekazone tracksaw system, and now there is a new system from PUPS (Portable Universal Power Station) that can turn a circular saw to an accurate miter saw.

What makes it easier to use a circular saw?

Knowing its parts makes using a circular saw easier. Handle and power trigger: While holding the handle to push the saw forward, squeeze the trigger to start the blade; release it to stop sawing. Trigger lock switch: This safety feature prevents the saw from being turned on if the trigger is accidentally squeezed.

How do you set a blade on a circular saw?

Attach the appropriate blade to the saw. Set the blade depth 1/4-inch below the material you are cutting. Confirm the bevel angle. Plug the saw’s cord into a power source or attach its battery. Rest the saw shoe on the edge of the material and near the cutting line. Lift the blade guard.

How do you guide a circular saw through plywood?

Hold the square in position as you guide the saw through the board. For longer rip cuts, such as for sheets of plywood, accessories like a saw guide can help you stay on track.

When to use 45 degree angle on circular saw?

It corresponds to the position of the blade when it’s set to 90 degrees, and should be used any time you’re making a normal cut. The line labelled “45” on the righthand side of the notch is for making beveled cuts at a precise 45-degree angle. Activate the saw blade by pulling the trigger on the rear handle.