Do toilets and showers drain to the same place?

Do shower water and toilet water go to the same place? – Quora. In the US, with modern regulations, in most municipalities, yes, they do. The water and solids from your toilet waste line and the water from your drains end up in the same sewer line, if you have access to a municipal sewer system.

Can sink and toilet share drain?

In conclusion, you can connect the sink drain to the toilet vent if the sink and the toilet vent are not far from each other. If it is not possible to connect a sink drain to the toilet drain within six feet of the toilet, you can install another vent on the toilet drain near the toilet.

What is the term for the run of pipe below toilets sinks and showers to the stack?

All plumbing waste fixtures use traps to prevent sewer gases from leaking into the house. Through traps, all fixtures are connected to waste lines, which in turn take the waste to a “soil stack”, or “soil vent pipe”.

How much does an Upflush toilet cost?

Upflush toilets typically cost $600-$800. A professional plumber can usually install one in an hour or two ($100-$200) for a total cost of $700-$1,000. Sewage ejector systems cost $400-$700 depending on the tank size.

Why does shower drain gurgle when toilet is flushed?

Help, my shower gurgles when I flush the toilet! Gurgling drains are usually caused by obstructions in the venting system. The gurgling sound is caused by air being forced through water in your drain trap. While the gurgling sound often comes from the shower/tub, it can also come from your vanity sink or toilet.

Can poop go down a shower drain?

Fecal matter would pass through a shower drain if the P-trap is made of 2” ABS, but the amount of water and velocity might not be enough to make it pass through. However, if the drain becomes obstructed you can probably clear it with aggressive plunging.

Are kitchen and bathroom pipes connected?

Your kitchen sink and bathtub have separate drain lines, but they ultimately all connect to a single line that leads into the sewer. If your sink is draining into your bathtub, something has definitely gone wrong somewhere in the plumbing lines.

Is toilet water connected to sink?

Sink water and toilet water are the same. Their water is being supplied from the same source. Though it may be supplied by different pipes, be rest assured that the water comes from the same source thereby making it the same. Remember you are not expected to drink water from the bathroom or toilet faucet.

Does every drain need a vent?

Whether you’re putting in a tub, toilet, sink, or floor drain, they all need a plumbing vent on the drain to make it work properly. The fixture without a vent may drain slowly. The drain will likely make gurgling noises. The water in the trap could siphon out, resulting in a potent sewer smell.

Does a vent stack have to go straight up?

Tips for Installing Vent Pipes Vent pipes must be installed so they stay dry. This means that they should emerge from the top of the drainpipe, either straight vertically or at no less than a 45-degree angle from horizontal, so that water cannot back up into them.

Do macerating toilets smell?

Why does my Saniflo smell? Bad smells can be due to a build-up of limescale and human waste in the 2-3 inches of water that’s always left in the Saniflo. To see if it’s your Sanilfo that’s emitting the bad smell, flush your toilet or fill your basin with water and then unplug it.

What is the best toilet for a basement bathroom?

Best Toilets For Basement

Saniflo SaniPLUS Toilet Kit.
Sanimove Macerating Toilet 3 piece Set.
Liberty Pumps ASCENTII-ESW Macerating Toilet.
INTELFLO Upflush Macerating Toilet System.
INTELFLO 600W Macerator Pump Toilet.

How do you install a toilet in an old house?

1. Turn off the water at the meter. 2. Open all faucets on the upper level of the house, then open the tub or shower valve in the bathroom where you’re installing the toilet. 3. Use emery cloth to buff clean the copper pipe stub-out protruding from the wall. 4. Put a shallow pan or a small bucket under the pipe stub-out to catch any water. 5.

How big of a pipe do I need for a shower and toilet?

Route the 3/4-inch cold water supply to it. Then branch a 1/2-inch cold and hot pipe from there to supply the shower. Branch one more 1/2-inch cold water pipe to supply the toilet.

Is there a way to install a shower in a basement?

Luckily, there’s another way. Here’s what you need to know. The best way to install a basement bathroom shower without damaging your floors is to look into an upflush toilet system. While traditional basement showers require you to drill into concrete to add a drain, a Saniflo system sits on top concrete floors.

Can a shower be connected to a toilet?

A small water heater installed near the shower will supply hot water more efficiently and economically than an underground pipe coming from your main water heater. Route the 3/4-inch cold water supply to it, then branch a 1/2-inch cold and hot pipe from there to supply the shower. Branch one more 1/2-inch cold water pipe to supply the toilet.

Is it possible to install a toilet in a bathroom?

On a serious note, it is absolutely possible to install a toilet, even a bathroom as a matter of fact, anywhere in your house. In the past, many homeowners have had the idea of their dream bathroom crushed because the location was simply too far away from the main drain.

Can you hook up a shower to a toilet?

Even better, a single Saniflo system makes it possible to hook a toilet, sink, and shower up to the same macerator and pump, which makes plumbing a breeze. An upflush system also saves you from damaging your pre-poured concrete and makes it easier to get the functionality you need.

What’s the best way to position a toilet in a bathroom?

If the toilet is opposite a shower, ensure that the door does not swing into the clear space of the toilet, or else install a sliding door. The position of the waste pipe also dictates the final position of the toilet.