How do I reset my power speaker?

Press and hold both the power and the “volume down” buttons for around 6 seconds until you hear the device power off. Turn on the speaker and use it as you would a new speaker.

How do I check the battery life on my Harman Kardon?

All you have to do is plug the unit into the charger. Push the “on” button and the “on” light will flash until the unit is fully charged. Hope you love yours as much as I love mine. It has great bass outdoors, blow your mind when inside, and will run the full 5 hours on battery.

How do I know if my Harman Kardon is charging?

All you have to do is plug the unit into the charger. Push the “on” button and the “on” light will flash until the unit is fully charged.

Where is reset button on jam speaker?

You will need a pin to press the reset button at the back of the speaker. Press and hold until you hear the audible response, “Resetting back to factory settings.” It will take the speaker some time to reinitiate, so please wait until the LED shows solid red before attempting to connect to it.

Why is my boom 3 not connecting?

Make sure your device is paired with your speaker and Bluetooth is active. Place your Bluetooth device closer to the speaker — it might be out of range. Move your Bluetooth device and speaker away from other wireless sources — you could be experiencing interference. Turn your speaker off, and then back on again.

Is there a problem with my Harman Kardon speakers?

My harman/ kardon speakers have worked without any issues for a year or so, but then my computer was reformatted and they don’t work anymore.

Is there a / B selector on Harman Kardon?

While there may be no A/B selector, there is certainly an individual speaker level setting and potentially the ability to disable each speaker. Thanks Bryan for the ideas. Actually tried those last night after performing the factory reset. Man, you really loose EVERYTHING after the reset.

What should I do if my speaker does not work?

If speaker continues to not sound correctly, a speaker or all speakers may have to be replaced. The device fails to start. Cable should not have any tears or kinks in the wire, connecting ends should not be bent or broken. Try wiggling the power cable in the charging port.

How do I Turn On my invoke speaker?

Ask Cortana, “Hey Cortana, pair Bluetooth”, or hold the Bluetooth pair button. The top panel will light up when in pairing mode. After entering pairing mode, turn on Bluetooth on the device you would like to connect and select the Invoke speaker.

What to do if your Harman Kardon speaker won’t invoke?

If problem with LED consists after following the previous troubleshooting steps, the LED may have to be replaced. Scratchy or unclear audio coming from speaker. Unplug power cable and wait ten seconds before plugging it back in. Once Invoke has turned back on, retry entering Bluetooth pairing mode. Warning! All settings will be erased.

Is the Harman Kardon audio system under warranty?

The unit is not under warranty anymore. On the ‘off-chance’ that every audio input feed into the receiver happened to fall out at the same time, I checked that. Ditto for the eight output speaker wires. Obviously that doesn’t/didn’t happen. No electrical storms in the area.

What happens to Cortana on Harman Kardon Invoke?

After the update Is installed, your Invoke will perform like other Bluetooth speakers – you will be able to pair it with your phone or other audio source and stream music to it. But Cortana and other Wi-Fi functions will no longer be available. Q: Is there a specified date for the firmware update de-coupling Cortana from the Invoke speaker?