How do you adjust the tension on a Taymor door closer?

To adjust backcheck, turn the regulating screw adjacent to the door hinges clock- wise. WARNING: Do not use backcheck function as a door stop. COVER: Locate top and bottom cover then push cover against the door closer. Tighten both screws securely.

How do you adjust international door closer?

LATCH speed adjustments is accomplished by full rotations of the speed adjusting valve. -Turn the speed adjustment screw CLOCKWISE for a SLOWER LATCHE arc closing speed. -Turn the speed adjustment screw COUNTER-CLOCKWISE for a FASTER LATCH arc closing speed. CAUTIONS!

Why won’t my screen door close all the way?

Screen doors fail to close properly when their hinges become imbalanced as a result of your home shifting or if the door frame has swelled or become loose. Swelling paint also can be a factor. The longer you go without correcting the situation, the greater the potential for permanent damage to the door or frame.

How do you adjust a door closer to open it easier?

Turn the “L” screw clockwise to increase the speed with which the door closes during the last one-third of its swing. Alternatively, turn it counterclockwise to reduce this speed. Increase the pressure it takes to open the door by turning the “BC” screw clockwise. Turn it counterclockwise to reduce this pressure.

How do you adjust the spring tension on a door closer?

How to Adjust a Self-Closing Spring Hinge Yourself

Remove the Locking Pin. Place the hex wrench into the socket at the top of the spring hinge and turn in either direction to release tension on the pin.
Tighten or Loosen in Small Steps. Rotate the wrench until the next hole comes into view and install the pin.

How do you adjust the speed of a door closer?

You can adjust an automatic door closer using only a ladder and the appropriate tool (screwdriver, hex key, or small wrench) by making small turns – less than 1/4 turn – of one of the adjustment screws. These screws will control the door’s closing speed, door delay, and door latching speed.

How to slow down closing speed on Taymor door?

Use socket key (included) to adjust these speed. To slow down closing speed, turn regulating screw nearest shaft clockwise. To slow down latching speed, turn regulating screw nearest latch clockwise. BACK CHECK: To adjust backcheck, turn the regulating screw adjacent to the door hinges clock- wise.

How to Mount closer door on push side?

PARALLEL ARM INSTALLATION – CLOSER MOUNTED DOOR ON PUSH SIDE 1. Before installation, turn Backcheck selector valve (found on the opposite side of closer from back check screw side) CLOCKWISE. 2. Adjust spring tension to match door width as indicated on the chart on page 1. 3. Mount closer using enclosed template with tube-end toward door latch. 4.

What happens if you turn your door closer 5 degrees?

A turn of five degrees can significantly increase or decrease closing speed. You will ruin the closer and void the warranty. Also, hydraulic fluid will leak out of the closer and make a mess. A door closer is a mechanical device designed to close a door slowly but firmly enough to latch.

Where is the tension screw on a door closer?

Locate the tension adjustment screw at the end of the pneumatic cylinder. Door closers consist of a pneumatic cylinder, which controls the speed of the door, and a bracket, which holds the cylinder to the door. Look at the end of the cylinder closest to the bracket, with the door closed, to see the adjustment screw.