What does ng Lcrslsrblbr mean?

The NG error code usually refers to a short in the amplifier system or one of your speaker channels. Please check all your wires and terminals at both the receiver and speakers to ensure that no copper is touching. From here we can power the unit back on to see if the error has been resolved.

How do I reset my Onkyo receiver standby?

To reset the AV receiver to its factory defaults, turn it on and, while holding down CBL/SAT, press 8ON/STANDBY. “Clear” will appear on the AV receiver’s display and the AV receiver will enter standby mode.

What does AMP DIAG mode mean?

If this is the case, when you turn the unit on again, “AMP Diag Mode” will appear on the main unit’s display. The unit will then enter a mode that detects abnormal conditions. If no problems are detected, “AMP Diag Mode” will disappear and the unit will return to a normal state.

Why does my receiver go into protect mode?

Your stereo receiver is going into protection mode because the receiver has an internal short, a speaker is bad or the speaker wiring has a problem, such as incorrect wire gauge or bad connections. If the receiver shuts off after connecting a speaker, that speaker’s wiring or the speaker itself has a problem.

How do you troubleshoot an Onkyo receiver?

Hold the “VCR/DVD” button while pressing the “On/Standby” button, and the receiver should enter “Standby.” Turn it on again by pressing the “On/Standby” button. Bear in mind that this will clear all the presets and other settings — but it may be those settings that are causing the problems.

What does resolution error mean on Onkyo receiver?

Any resolution set on the receiver that is not supported by the TV will result in no video output through the HDMI connections. The Onkyo receiver will display a “Resolution Error” message. Use a resolution setting that is supported by your TV to fix the problem.