What is check sp wire?

If “CHECK SP WIRE” appears on the display, the speaker cables may be short-circuited. Make sure bare speaker wires are not touching each other or the back panel of the unit, then turn the unit on again.

How do I fix my amp channel?

Turn the amp off and reverse the speaker wires at the back of the amplifier by moving the right channel wires to the left outputs, and the left to the right. Turn it back on. If the problem stays on the same speaker, the speaker or wire on the bad side is defective. If it reverses, it’s the amp.

How do I reset my Pioneer receiver 1022?

Please try doing a RESET on the unit: Power it Off. On the front panel hold the BAND button and press On/Standby. When you see RESET on the front panel press AUTO SURROUND/STREAM DIRECT.

How do I reset my Pioneer AV receiver VSX 531?

Switch the receiver into standby mode by holding down “Band” and then pressing and holding the “Standby/On” button for about two seconds. When you see “Reset?” appear on the display, press either the left or right arrow button or the “Auto Surround/Stream Direct” button until “OK?” is displayed.

What is AMP DIAG mode?

If this is the case, when you turn the unit on again, “AMP Diag Mode” will appear on the main unit’s display. The unit will then enter a mode that detects abnormal conditions. If no problems are detected, “AMP Diag Mode” will disappear and the unit will return to a normal state.

What are banana plug speakers?

So named for its resemblance to a favorite source of potassium and pratfalls, the banana plug is used to finish off the exposed ends of speaker wire and make them easier to plug into your receiver or speakers.

How do I turn off the HDMI on my Pioneer receiver?

Currently in order to be able to switch between the amp decoding the audio from the HDMI sources or it passing the audio through to the TV you need to go into the Audio Parameters menu on the receiver go up or down a few options and then you can toggle using the left and right menu buttons between two options.

How do I reset my Pioneer VSX 531?

What’s the arc channel on a pioneer receiver?

Any help greatly appreciated! ARC is audio RETURN channel. That is for bringing audio FROM the TV back to the receiver. That option will not affect your issue. What you need to look for is an option in the receiver to output HDMI to the amp or passthrough to your TV.

Is there a pencil hole in my pioneer a / V receiver?

It’s a THX badged, 5.1 system from about 2 or 3 years ago. It does have a flip down panel on the front, but I can’t see a pencil hole?

How to reset a pioneer a / V receiver from protection mode?

Thanks again. I have an Onkyo TX-DS575X that is apparently in protection mode…any ideas on how to reset it? unplug it and hold the power buton for 5 seconds.i dunno if that’ll work cuz its instructions on how to reset a Kenwood vr-6070 but it might, try it.

Why does my pioneer a / V receiver sound like a shower?

The thing is if you leave it off for a good few hours and then switch it back on it works fine for a few minutes and then you start hearing the occasional pop. The pops gradually increase over the next few seconds to sound like a shower coming down outside.

It’s a THX badged, 5.1 system from about 2 or 3 years ago. It does have a flip down panel on the front, but I can’t see a pencil hole?