Why does my receiver cut out?

If a receiver is not getting enough current, it will turn itself off. If your receiver shares a wall outlet with another high-current appliance (e.g. refrigerator, air conditioner, heater, or vacuum) the receiver may shut itself off when there is insufficient current.

Why does a subwoofer have a left and right input?

Since the subwoofer is responsible for low bass tones (aka its sole purpose), it requires a transmitter of low-frequency audio waves. The left and right channels are combined in an LFE cable to allow for a singular cable to evenly disperse the signals to the subwoofer.

What do discrete amps do on Onkyo tx-sr353?

Discrete Amps deliver high instantaneous current to increase speaker control for accurate and dynamic audio reproduction. This precise power is the cornerstone of Onkyo’s amplification philosophy. This gives the TX-SR353 140 W/Ch (6 Ohms, 1 kHz, 1.0% THD, 1 Channel Driven) 80 W/Ch (8 Ohms, 20 Hz–20 kHz, 0.08% THD, 2 Channels Driven, FTC).

Can a subwoofer be connected to a two Channel Receiver?

Besides, you can decide whether you need to activate the subwoofer for two-channel audio sources or not. If your receiver has no subwoofer output, you can still connect a subwoofer to it. Check in the rear panel of the receiver to see whether it has a preamp output or not. It is usually marked as ‘pre-out’.

Is the subwoofer from partsexpress too weak?

Subwoofer sounds very weak. Today, my subwoofer from partsexpress finally came. Hooked it up and feel disappointed at this time. I don’t know what I am doing wrong.

How can I connect my subwoofer to my AC receiver?

Find out the subwoofer setting in your receiver. The ‘bass out’ feature of your AC receiver assists you to realize when and how you can operate your subwoofer. Then, set the ‘mains + LFE’ for allowing your subwoofer to play when the front speakers are arranged to large. Also, there are some receivers with bass management facility for two channels.

How to fix Onkyo tx-nr636 arc no audio problem?

Solution to Onkyo TX-NR636 ARC no audio problem 1 Go into Hardware Setup. 2 Select HDMI 3 Turn RHID (CEC) Off, and exit out of the menus completely. 4 Go back into the menu system and turn RHID (CEC) back on, and here’s the tricky part, exit completely out of the menus, and after the last step out

What should I do if my Onkyo receiver shuts off?

Some brands provide 1-3yr warranty. First up you might want to try disconnecting everything from the receiver (speakers, hdmi…whatever other cables) and see if it still shuts off ..if it doesn’t might want to start hooking stuff back up on at a time (double checking for frayed speaker wires and for shorted connections on the speakers themselves.