How do you install a solenoid valve? Positioning of the solenoid valveIt is recommended to install the valve in a dry and ventilated environment. The valve gets hot during use. Most solenoid valves can be used in one flow direction only. The best way to install the valve is with the coil facing upward with a maximum deviation of 90 degrees (see picture). Can a solenoid valve be installed vertically? Generally, the installation of solenoid valve should ensure that the solenoid coil part of the solenoid valve is vertical upwards and the valve body horizontal. Thus it should be installed...

Why is my shower drain making noise? As water flows through a drain, it's displaced by air which helps it move through your pipes. If air wasn't able to escape from your pipes when water traveled through without interrupting the flow of the water, you would hear those loud gurgling noises. Plumbing vent systems allow for exactly that to happen. Why does my shower drain make a gurgling noise? Gurgling noises can also be caused by shower drains that don’t have a p-trap or drains where the p-trap is damaged or broken. What is a p-trap? This is a piece...

What to do if your Pipes are making loud noises? So if you are noticing loud, knocking noises from your pipes, you will likely need to contact a professional plumber to have water hammer arrestors installed. See below for more info on water hammer arrestors. Why is my water pipe so loud when I turn it off? When water is running and is then suddenly turned off, the rushing liquid has no place to go and slams against the shut-off valve. The loud, thudding sound that follows is known as a water hammer. Besides being alarming, water hammer can potentially...

How is water bled out of a fire hydrant? It is very important that when the system is reactivated that the water is turned back on very slowly and that air inside the pipe is bled out by opening the fire hydrants. In addition any loose sediment should also be bled out through open hydrants. What to do when a fire hydrant flushes? If you notice that there’s a hydrant flushing in your neighborhood or the water at your tap looks rusty, it’s best to run cold water from each tap until it runs clear. If you have an ice-maker...

What does it mean when your hot water is only warm? Sediment Is Affecting the Heating Element When this water flows into your water heater tank, the minerals tend to build up at the bottom of the tank. The resulting sediment can reduce the lower heating element's effectiveness, causing only lukewarm to flow from your hot water tap. Why does hot water come out of cold water tap? When the outside environment is too hot, you can turn the faucet on for 1 minute and let some water flow before touching it. After some while, the water will become cold...

Can you flush toilet if water pressure is low? While the water is running, flush the toilet. If the water pressure has a noticeable drop in pressure as soon as you flush, the toilet is the cause of the low water pressure. If the water pressure remains steady, the problem is elsewhere. Can You flush a toilet with no water? The water can be bottled water or from any other source that you can use to flush your toilet. While you do not have running water, and you are using a bucket, you need to make sure that while pouring...