Info

The hedgehog was engaged in a fight with

Read More
Lifehacks

What size is the set screw on a bathtub faucet?

What size is the set screw on a bathtub faucet? 1/2" The 1/2" nominal inside diameter ( CTS ) slip-on adapter slides over the copper tubing and is secured to the copper pipe by tightening the set screw, or can be sweat/soldered to the pipe. Once the brass adapter is secured to the pipe the tub spout is threaded onto the adapter. How do you get a bathtub faucet off? Stick the screwdriver into the hole in your faucet and push it up to turn the spout counterclockwise. Once it's loose, unscrew it with your hands. Pull the spout from...
Popular

Should a humidifier be hooked to hot water?

Should a humidifier be hooked to hot water? When the humidifier is wired to operate on a heat or HVAC fan call, hot water is required as it is the only heat source for the evaporation process during an HVAC fan call. In addition hot water is required when the humidifier is connected to a heat pump. This is due to the lower plenum temperature in a heat pump. Should my humidifier be on hot or cold? Hot water might also cause burns in the event of a spill. Humidifiers add moisture to the air. Cool-mist humidifiers may help ease...
Tips

How do I add pressure to my heating system?

How do I add pressure to my heating system? Locate the filling loop, often found on the underside of your boiler. Open both valves to allow water into your heating system. Keep an eye on the pressure gauge and close the valves when the pressure reaches 1.5 bar. Switch on your boiler and reset the fault code (if necessary). Can you bleed radiators when the heating is on? You can't bleed a radiator when the heating is on, as it may be too hot to touch. You could also get hot water spraying out of the radiator. Use your radiator...
Miscellaneous

What to do when your shower pressure is low?

What to do when your shower pressure is low? Clean Out Sediment. Over time, mineral deposits and scale clog up your shower head. This is not a matter of "if" but "when," since all water (unless distilled water in containers you purchase at the store) carries minerals. Unscrew the shower head and let it soak in a bowl of vinegar for at least eight hours. What should I do if my shower drain is clogged? Sometimes you can clear a clog in metal pipes by simply emptying a kettle of boiling water down the drain, a little at a time....
Miscellaneous

What is the typical plumbing abbreviation for a toilet?

What is the typical plumbing abbreviation for a toilet? WC Plumbing and Fire Protection AbbreviationsIDInside DiameterVTRVent Through RoofWWasteWCWater Closet (Toilet)WHWall Hydrant Is a toilet a fixture? Fixture. A device for receiving water and/or waste matter that directs these substances into a sanitary drainage system. Examples include toilets, sinks, bathtubs, shower receptors, and water closet bowls. What is the plumbing code for a bathroom? The two major plumbing codes in the United States is the IPC (International Plumbing Code) and the UPC (Uniform Plumbing Code). The table below lists each DWV fitting used to plumb this simple bathroom. Notice each plumbing...
Miscellaneous

Why is my shower running slow?

Why is my shower running slow? Limescale and sediment build-up causing low water pressure in the shower head: This can be fixed by simply cleaning or replacing the showerhead. Restrictive valves on the showerhead: A low-flow showerhead may have been fitted to your shower, or your showerhead may have a valve that restricts the flow of water. Is it bad to take a hot shower in the morning? We love a restorative shower for its day-starting, head-clearing, muscle-relaxing power. But that long, hot shower that starts your day might not be doing your skin any favors. Too much hot water...
Lifehacks

Can you pour concrete over underfloor heating?

Can you pour concrete over underfloor heating? The Layers of Underfloor Heating You can't just lay heating and spread concrete over it. There are usually four key layers to the process which will help to make your heating both efficient and long lasting. Can concrete floors have radiant heat? Radiant floor heating provides a similar effect in your home or office. Electric heating coils or water-heated tubing are installed into the concrete slab when it is poured. When this process occurs, the thermal mass of concrete is transformed into a radiator of warm, even heat. Should a hydronic heating system...
Popular

Why does my toilet flush but not clog up?

Why does my toilet flush but not clog up? The constant gush of hard water through these holes may cause the buildup of minerals. This buildup can make the holes smaller and smaller, decreasing the water that goes through and thus causing a weak flush. Not enough water in the tank. Is there cold water in the bathtub upstairs? Check the level of water in the header tank upstairs. Been up into the loft & tank does'nt appear to be frozen. Where does the water go when there is no water in the toilet? There are two parts of any...
Tips

Why do I get hot water everywhere but the shower?

Why do I get hot water everywhere but the shower? We’ll show you how to determine which is your problem and what you should do to fix it. If you’re getting hot water everywhere but your shower, it could be that your anti-scald device is set at too high a limit. Anti-scald devices (also called a “hot limit stop” or “rotational limit stop”) are safety features that most faucets have. How can I get hot water out of my shower? Take the handle or head off of your faucet. Depending on your faucet model, you may need a screwdriver or...
Tips

What happens if boiler pressure drops to 0?

What happens if boiler pressure drops to 0? Majority of the time, pressure loss is due to a leak in the boiler itself or somewhere in the heating system. Unless the dial sits at 0 even when topped up (which could indicate a faulty pressure gauge), it's likely a leak is the culprit — even if you can't pinpoint it! Why is my boiler pressure Zero? Why is my gas boiler pressure too low? The most common reason for your gas boiler pressure being too low is either a water leak somewhere in the system or reduced system pressure as...