How do you plunge a toilet step by step?

The steps to plunging a toilet are simple:

Put the plunger with the bell shape covering the toilet trap and exert a small amount of force. This gets all the air out of the plunger without blowing water everywhere.
Once the air is out, you can start exerting more force and plunging in and out.

How do you properly use a plunger?

Submerge the plunger (the top of the bell should be covered with water) and make sure the rubber ring is inserted directly into the drain opening. Push and pull on the handle with quick, concentrated thrusts for 20 seconds without lifting the plunger out of the drain and breaking the seal.

How do you plunge a toilet full of toilet paper?

Thus, inserting a toilet auger into the toilet drain will assist in breaking up the stuck toilet paper and allow it to dissolve in water. To do this, insert the barbed or hooked end of an auger into the opening of the toilet drain. Push it down the drain and stop when you notice some resistance.

How do you know if you unclog the toilet?

Plunge Correctly Give a few good up and down strokes with the plunger and flush the toilet. If the water clears from the toilet, then you’ve successfully unclogged it. If the toilet starts overflowing again, just close the flapper to stop water from entering the bowl.

What does a toilet plunger look like?

A toilet plunger has a flange at the bottom and it’s shaped like a bell. It’s also called a flange plunger and is black. The flange gets inserted into the large drain of the toilet while the bell portion rests on the bottom of the toilet bowl. Just flip it over and pull out the flange.

How do you know if a plunger is working?

Does a plunger push or pull?

When you pull up on a plunger, it pulls water in the drain upward, beginning the process of loosening the clog. When you push down on the plunger, water is forced downward, moving the clog in the other direction. Keep the two forces in mind when plunging your drain.

Can too much toilet paper clog a sewer line?

Excess Toilet Paper Use Though toilet paper is designed to be flushed down the drain without issue, using too much does lead to recurring toilet clogs. The tissue simply does not dissolve quick enough, so matter becomes stuck in the toilet or the sewer line.

Should you flush a clogged toilet?

The most important thing you can do in this situation is don’t flush a second time. Forcing the toilet to flush again releases gallons of water into the toilet bowl and will cause an overflow. A second flush will only create another disaster, in addition your current problem. Remember: don’t flush again!

What does a flange plunger look like?

Flange plungers look very similar to cup plungers. The difference is that a flange plunger has a longer handle and a soft, smaller cup (known as a flange) that extends down the bottom end of the plunger.

How to use a toilet plunger to plunge the toilet?

How to Use a Toilet Plunger to Plunge the Toilet. For the best results, warm the rubber cup on the plunger with hot water for 30 seconds. Place the toilet plunger in the bowl and try to seal it over the toilet drain. You can rub some petroleum jelly along the rim of the flange to create a better seal.

How do you clean a plunging toilet without damaging it?

Minimize cleanup by heaping dirty rags or old towels at the base of the toilet. The fabric here becomes the landing area for any water that splashes out during the process. Another cleanliness-oriented tip: Before plunging a toilet whose bowl is completely filled with water, don gloves and use buckets to bail out half of the fluid.

Can You bail out a toilet plunger with water in it?

Unless the bowl is so full that you can’t plunge without sending water everywhere, you shouldn’t bail out any of the liquid inside. There needs to be at least enough water to cover the head of the plunger.

How do you fix a toilet that keeps filling up?

Bail out water with a bucket if the toilet bowl is close to overflowing. If you tried flushing the toilet before, the water may have filled the bowl to the rim. Put on rubber gloves and dip a bucket into your toilet. Remove water from the toilet until it’s halfway full so it doesn’t overflow.