How do I reset my Cisco 6921 phone?

How do I reset my Cisco 6921 phone?

How to: How to do a factory reset of a Cisco 6921 Phone

1. Step 1: While powering up the phone, press and hold #.
2. Step 2: Wait forHandset & mute button turn off, all other Lights stay green.
3. Step 3: Wait for phone to reset.

How do I setup my Cisco IP Phone CP 6921?

Cisco 6921 IP-phone setup Choose the network interface to which phone is connected. Admin Settings > Network Setup > ipv4 setup > click down > Alternate tftp server > switch on YES > click down > tftp Server > enter the IP-address of the PC on which the tftp-server is installed.

How do I reset my Cisco IP Phone?

Follow the steps below to successfully factory reset your Cisco 7942, 7962 IP phone:

1. Unplug the power cable from the phone and then plug it back in. The phone begins its power up cycle.
2. While the phone is powering up, and before the Speaker button flashes on and off, press and hold #.
3. Release # and press 123456789*0#.

How do I reset my Cisco 7940 to factory settings?

1. Step 1 How to reset Cisco 7940 / 7960 IP phone to factory defaults.
2. Immediately press and hold # and while the Headset, Mute, and Speaker buttons begin to flash in sequence, release #.
3. Press 123456789*0# within 60 seconds after the Headset, Mute, and Speaker buttons begin to flash.

How do I reset my Cisco IP phone remotely?

Reboot the phone remotely. Open the SMP web interface. Then click the reboot link next to the phone you want to reboot.

How do I Reset my Samsung Galaxy 6921 to factory settings?

Gordon I was able to do the factory reset on the 6921 by: Step 1 Unplug the power cable from the phone and then plug it back in. # The phone begins its power-up cycle. # Step 2 While the phone is powering up, and before the Speaker button flashes on and off, # press and hold #. #

What happens when I factory reset the Cisco Unified IP phone?

When you perform a factory reset of the Cisco Unified IP Phone, the following information is erased or reset to its default value: • Phone application—Erased (phone recovers by using the image in the inactive partition of flash to boot up). Before you perform a factory reset, ensure that the following conditions are met:

Is the phone registered with the Cisco Unified Communications Manager?

The phone is not registered with the Cisco Unified Communications Manager. A Cisco Unified IP Phone can register with a Cisco Unified Communications Manager server only if the phone has been added to the server or (if autoregistration is enabled) there is a sufficient number of unit licenses.