How do I reset my digital safe?

Place the electronic digital safe into code reset mode. On some models you need to hold the last digit of the code or press the “*” button to get into code reset mode. Other safes require you to open them and press a small red button on the inside of the door.

How do you unjam a safe?

Jammed Bolt Work Turn your back to the safe, and kick the door, hard, a few times. Be sure that you do not kick the keypad or the handle. This will help loosen the bolt work. Next, pull the handle in the opposite direction than you normally do and enter the code.

How do I change the combination on my digital safe?

Enter your current digital safe combination on the keypad followed by #. Open the safe by pulling downward on the latch and pulling the safe door open. Push the red passcode reset button inside the safe door. Listen for the digital keypad to beep three times, indicating it is ready for you to enter your new passcode.

What happens when you can’t open your safe?

When your safe doesn’t open, you may go ballistic only to find later on that the culprits are the dead batteries. Even your keypad normally beeps and lights, so make sure to check the batteries first. They may have remaining power but not enough to pull off the bolt work.

When do I change the batteries on my safe?

Use quality name brand batteries. All batteries have expiration dates on them. Ensure those dates are as close to 10 years out from current year as possible. When changing batteries do not mix brands (i.e. all 4 batteries should be Duracell) or mix old batteries with new batteries.

What should I do if my safe battery is low?

If battery is low and unable to operate open, use Battery Auxiliary Override. This should not be used as a primary means of gaining entry into safe. Open the silicone cap found on the side of the electronic lock. Insert a 9 volt battery into slot.

Can a digital safe be opened if the batteries are flat?

It is therefore only natural that doubts can arise about what could happen in the case of an unexpected event. One of the most common fears is that of no longer being able to open the safe once the batteries are flat. Also in this case, the difference depends on the quality of the product.

Why is it bad to mix new and old batteries?

In fact, it will reduce performance and may even damage your device or cause battery leakage or rupture. As well, do not mix different battery brands within a device. Doing so will reduce overall performance and may also cause battery leakage or rupture.

How to change the batteries in a Liberty Safe?

Read above as it is the same procedure as in a direct drive Liberty Safe. To replace your lock battery, first locate the screw underneath the keypad and remove the cover. Disconnect the old battery and replace it with a new one. Fully insert the new battery until it is no longer exposed. Put the screw to reattach the cover.

What to do if you have electrical issues after replacing a battery?

If you’re experiencing electrical issues immediately after a battery replacement or disconnect, make sure the battery cables were re-attached and tightened down properly. Herculean strength isn’t necessary, but the cables should be snug and not move around or come off of the battery posts.

How to change the batteries in a Sentry Safe?

1) How to change the batteries in a Sentry Safe remove the screw located at the bottom front of the keypad using a Phillips head screwdriver, rotate the keypad clockwise and remove to reveal the battery drawer, remove batteries and replace with new AA alkaline batteries,