How do you take the top off of a Whirlpool Cabrio Platinum washer?

The clips are about 4″ in from each corner on the front where the top hits the front in the small crack. The easiest way to get the top off is to remove the two screws coming in from the back and lift the back of the top up slightly and push it forward then reinstall the two screws so the lid can tilt back..

Where is the filter on Whirlpool Cabrio washer?

For front-loading machines, the filter will be in the bottom right corner on the outside of the washer. If you have an older top-loading washer, your filter will also be in the bottom right-hand corner of the machine.

Why my Whirlpool Cabrio lid lock light is flashing?

– Actuator motor is faulty or has loose wiring (If washer is VMW = Vertical Modular Washer). How To Fix The Lid Lock Light Flashing On My Top Load Washer: – Be sure lid lock and lid striker are clean as lint or detergent buildup can block the switch and cause the flashing light.

How do I reset my Cabrio top load washer?

How to Reset a Whirlpool Cabrio

Touch any key on the display pad to clear the error code, if applicable, or press “Pause/Cancel.”
Choose a new cycle and press “Start” to begin.
Turn off and disconnect the Cabrio if the error or problem persists.
Wait several minutes before restoring power.

Why won’t my Cabrio washer fill with water?

Washing Machine Won’t Fill Because Water Inlet Valve Defective. Washing machines have a water inlet valve that allows both hot and cold water into the unit. No continuity indicates an issue with the valve. When the water inlet valve is the cause for a Whirlpool Cabrio washer not filling with water, it must be replaced.

What is the problem code DL on the Cabrio washer mean?

The Cabrio Washer DL error code happens when the main control detects a problem with the lid lock assembly not being able to lock properly or the control cannot determine if the door lock assembly is in a locked or unlocked state. The steps to take to try and remedy this error are below.

What does LD mean on Whirlpool Cabrio washing machine?

Whirlpool Cabrio Washer Error LD. The Cabrio Washer LD error code stands for Long Drain which means the control has recognized the water in the tub is not draining fast enough during the cycle.

What does LF mean on the Whirlpool Cabrio washing machine?

Whirlpool Cabrio washer with error code LF. This error means Long Fill (LF). It basically means that if the machine has not filled after 10 minutes then it goes into this error condition. First thing to do is make sure the taps are turned on.