What is a thumb latch lock?

The Thumb Latch features a reversible design for use of left- or right-hand doors up to 1 ½” thick. Note: Generally used on an in-swing door so that the thumb bar is on the outside and the lock is on the inside. Out-swing doors are not very common in residential construction but often used for closets.

How does a door thumb latch work?

The thumb piece passes through the door and raises the latch bar off the keep creating a charming clanking sound as it does so. A staple pin or screw-on staple is used to restrict the latch bar movement.

What are the push handles on doors called?

A crash bar (also known as a panic exit device, panic bar, or push bar) is a type of door opening mechanism which allows users to open a door by pushing a bar.

How do you remove a thumb latch door handle?

You need to slip a small screwdriver over the lever and slid it in the direction that the arrow indicates. This will release the interior knob from the door. Then, you can pull the knob free.

What does pushing a pull door mean?

When a door does not require latching hardware, push and pull plates are often used. They facilitate the operation of the door by pushing or pulling the door as you enter or exit through the opening. These are popular in high traffic areas such as secondary vestibule doors or large restrooms.

How do you remove a Baldwin thumb latch door handle?

There should be a small latch near the base of the knob or handle, probably on the exterior side of the door. Push this latch in, and pull the handle off the door. Next, find a small slot on the edge of the trim piece. Insert the tip of a screwdriver and pry off the trim piece.

How do you fix a Baldwin thumblatch door handle?

An easy way to do this is to slide the plate back on to the lock under a few of the tabs, and then tap the other side back on with a screwdriver. It should go back on fairly easily. If you didn’t break off more than a few of the tabs, the plate should now be secured and the handle set ready to put back onto the door. That’s it.

Why is my thumblatch not working on my door?

Thus the latch will not move and the door will not open. Now you’re almost done but this step is important. Take that round gear off it’s not held in there by anything. Push the thumblatch up all the way until it stops (that’s the thing you push down on the outside of the door to open it).

Are there any thumb latch door hardware left in stock?

Only 2 left in stock – order soon. . Only 12 left in stock – order soon. . Only 3 left in stock – order soon. . Only 9 left in stock – order soon.

Why is the handle on my Baldwin thumblatch falling off?

The set screw on the interior handle may be loose and the knob or lever falling off. That isn’t what we’re here for today though. We’re here because of another common point of failure: the Baldwin thumblatch assembly, or, more specifically, the teeth on the gears failing.

How can I fix the handle on my front door?

Apply a little powdered graphite into the mechanism to loosen up stiff moving parts. Push the mechanism back into position and replace the screws on the side of the door. Insert the outside handle first and then the inside piece making sure the square metal rod passes through the mechanism.

What kind of handleset do you need for a double door?

These should only be used where there is another escape route easily accessible. Double Door Entry: If you have a double front door where one side is generally inactive while the other is always active, you will need a combination of two handle sets. For the active side, you’ll need a handleset with a single cylinder deadbolt.

What are the parts of a door handle?

Specific details will vary for different door handles. Parts covered in this video: handle, rosette, latch, latch assembly, and locking mechanism. The locking mechanism was simplified a lot. If you were to take a real one part you would find a lot more intricate parts. http://www.youtube.com/timedtext_vide… Loading…