What to do if your Trane air conditioner is not working?

Consult your local Trane Comfort Specialist™ if you are unsure where the filters are located. Your thermostat controls may be set incorrectly Try turning the thermostat off and then on again. Reset to the desired temperature and see if that helps.

How do you change a filter on a Trane?

Locate access door marked “FILTER” and lift up the open side of the levers. Slide dirty filter out, replace with a new filter making sure the arrows printed on it are pointing in the direction of airflow. Hold the “FILTER” door firmly in place and snap the levers down (closed). Your filter may or may not be framed.

What do you need to know about a Trane air handler?

The qualified installer or agency must use factory-authorized kits or accessories when modifying this product. Disconnect all electric power to the indoor air handler or furnace before removing access panels to perform any maintenance. Disconnect power to both the indoor and outdoor units. A clean filter saves money.

How does the Trane xe90 gas furnace work?

This gas furnace has a patented heat exchanger that is designed with a serpentine-shaped channel. When air flows over the heat exchanger, hot gases are pulled through the channel by an induction vent fan, rather than escaping up the flue.

What’s the average efficiency of A Trane 95 gas furnace?

Trane 95 and 90 gas furnaces deliver at least 90% efficiency, far exceeding the government minimum standard of 80 AFUE for new furnaces. If you have a furnace that is at least 10 years old, it probably has an AFUE somewhere between 60 and 70 – meaning up to 40 cents of every dollar you pay for fuel is wasted.

Ask your Trane dealer where the filter is located in your system and how to service it. Just be sure to replace it with the arrows pointing in the direction of the airflow. AIR CONDITIONER NOT WORKING? Here a few common problems and quick fixes to try if your air conditioner isn’t working properly.