What does F mean on a Kenmore washer?

component problem
The F indicates that the washer control detected a component problem. If the F code was caused by excessive suds preventing the washer from draining, you may be able to shut the door and run a drain/spin cycle to remove the water from the washer.

What does the code mean on a Kenmore washer?

If the load is unbalanced, the washer will display this code while running an imbalanced load correction routine at the end of the wash cycle and before the final spin. If the code remains and the wash cycle dial is flashing after the recovery routine has stopped, open lid and redistribute the load.

What’s the model number on a Kenmore top load washer?

These error code explanations can help you diagnose a problem with your Kenmore top-load VMW washer with a model number that starts with 110.

What to do if your Kenmore washer is not working?

Select PAUSE/CANCEL twice to cancel the cycle. Select DRAIN & SPIN if there is excessive water in the washer. Re-select cycle and press START. If the problem remains, call for service. If any of these codes continue to occur, call for service. Washer displaying code messages.

What happens if drive block on Kenmore washer is worn out?

The drive block connects the agitator to the washer’s transmission. If the drive block becomes worn out, the transmission shaft will still move, but the agitator won’t. You’ll need to inspect the drive block to see if it has any damage. If it’s stripped, damaged, or worn out, replace it.

What do the Kenmore front-load washer error codes mean?

Kenmore Front-Load Washer nd Error Code. The nd error code on your Kenmore front-load washer means water isn’t draining from the washer. The likely causes are a stopped-up washer drain or a clogged drain pump filter.

What does error code F1 mean on Kenmore washer?

On a Kenmore Oasis washer, the F1 error code means that the water level sensor isn’t working correctly. That water level sensor is a component on the electronic control board in the control console of the washer. Unplug the washer and replace the electronic control board to fix this problem.

What is Kenmore Elite washer error code F6?

The F6 fault code indicates a drive motor tachometer error . The control unit for the washer is not able to properly detect drive motor speed. The troubleshooting for this fault code involves. unplugging the washer. and checking the wire harness connections between the drive motor and the motor control unit (MCU).

What are the error codes for my Kenmore range?