How do you adjust the water dispenser on a Whirlpool refrigerator?

How to Calibrate Measured Fill

Place a sturdy measuring cup (1-cup [237 mL] size) on the dispenser tray centered in front of the ice/water dispenser paddle.
Touch and hold the MEASURED FILL button for 3 seconds.
Press and hold the water dispenser paddle, to dispense water to the 1-cup fill line in the measuring cup.

Why is my water not coming out of my fridge?

A buildup in food particles or debris can clog the drain hose, leading to ice buildup and water leaking out of the freezer and fridge. A clogged or frozen water supply can also cause water to leak on the floor and puddle under your fridge. This can also prevent the icemaker and water dispense from working properly.

Which way does the lever go to make ice?

Does the ice maker lever go up or down? The wire arm when it is raised up and locked will shut the ice maker off. When it’s in the down position a lever will strike and close the on/off switch so that the ice maker is on. The wire arm is pulled down by a small spring.

How do you take apart a Kenmore water dispenser?

How do you remove the water dispenser from a Kenmore Elite?

Remove the Dispenser.
Unplug the refrigerator’s power cord from the wall outlet, or turn off the breaker in your service panel.
Pull the drip tray away from the bottom of the dispenser and remove.

How do you replace a water dispenser on a refrigerator?

Insert the side pins of the new water dispenser lever into their seats on the back of the control module. When done correctly, the lever will pivot forward and back on the pins, which serve as a simple hinge.

Why does my water dispenser not turn on?

When the water dispenser lever will not work or depressing the lever causes little to no water flow, there may be air in the water dispenser supply lines or a broken lever mechanism that needs to be replaced. The plastic actuator levers have small arms on the top that trigger the water dispenser when they are depressed.

Where is the water reservoir on a new refrigerator?

(No or Slow Water from Dispenser) If your refrigerator is newly installed, make sure you push the water dispenser lever down for 3 minutes to get the water reservoir to fill up completely. Usually the water reservoir is located inside the fresh food section.

How do you replace a water actuator on a refrigerator?

Plug the plastic wire harness connector back in. Insert the water dispenser unit into the refrigerator door and slide it down to snap it in place. Drive the screws into the dispenser unit screw holes with a screwdriver. Set the drain cover back in place. Plug in your refrigerator and test the water actuator lever.