Info

The hedgehog was engaged in a fight with

Read More
Q&A

How much does it cost to pave a driveway in NJ?

How much does it cost to pave a driveway in NJ?

Paving an asphalt driveway costs $4,795 on average, with a typical range between $2,966 and $6,664. This project runs $7 to $13 per square foot, including $2 to $6 per square foot for materials and $5 to $7 per square foot for labor. If you need replacement, you’ll pay $8 to $15 per square foot.

Why does it cost so much to pave a driveway?

Labor. Labor also drives the cost of driveway paving since it’s a labor-intensive process. The labor cost to pave an average 450-square-foot driveway could run $5 to $7 per square foot or about $2,250. A driveway that has curves or is circular will cost more to complete, so labor costs will also increase.

How much does it cost to pave a driveway with pavers?

What Is the Cost of Paving a Driveway?

How much does it cost to put pavers on a driveway?
Exposed aggregate finish $100 to $150 per m2
Natural stone pavers $75 to $100 per m2
Brick pavers $70 to $90 per m2
Plain concrete driveway $75 per m2 (on a sloping surface) $65 per m2 (on a flat surface)

Do I need a permit to asphalt my driveway in NJ?

No, a permit is not required unless you are relocating the driveway or increasing the size of the driveway. If that is the case, then you will need to apply for a zoning permit.

Is it cheaper to pave a driveway or concrete?

Cost. The cost of an asphalt driveway is typically cheaper than concrete, costing $2.00 – $4.00 per square foot. In contrast, a concrete driveway costs between $4.00 – $6.00 per square foot for a standard installation. Finishes, details and stains can increase the price tag to as much as $15.00 per square foot.

Can I add a driveway to my house NJ?

The driveway must be 5 feet from the property line. However, if the driveway already exists and is less than 5 ft from the property line, it is grandfathered. Any widening of your driveway less than 5 ft from the property line requires an administrative waiver from the Land Use Office in addition to a plot plan.

How close to property line can driveway be?

Pretty much a standard, though, is that it must be eight feet back from the property line for any permanent structure with a roof. A driveway can be right at the property line, but not a garage, and in most cases not even a permanently-built carport, with just a roof.

Can You pave driveway up to property line?

Depending on your local laws, you may be able to pave a driveway right up to the line. In the case that you’re not allowed, you try asking your town for permission. If you are unsure, read on for some tips and guides regarding driveway and property lines.

What should I do if my Neighbor has a driveway?

If your neighbor is not willing to remove the driveway that encroaches on your property but is otherwise open to negotiations, then proper communication will be very helpful. You might want to suggest that usage of the encroached-upon land should come with an annual fee, for example.

Do you need a land survey to move a driveway?

Should there be encroachment issues that need to be resolved, the first thing to do is to have a land survey done by a professional. If for instance you want the neighbor’s driveway moved, then you need a proper land survey to determine if the driveway is indeed crossing your property.

How big of a setback do you need for a driveway?

The side setback is usually 5 feet minimum (on each side) for most regular neighborhoods. In some areas, you can indeed pave a driveway just on the property line but you still have to verify this with the local government. If you’re building a structure, however, then it’s certain that there are required wider setbacks.

Miscellaneous

How much does it cost to pave a driveway in NJ?

How much does it cost to pave a driveway in NJ?

In terms of cost, asphalt paving typically runs about $3.00 to $4.00 per square foot depending on the scope of the project (quality & topography of your property, slopes, curves, etc). Concrete is another choice, but typically runs about $6-7.00/SF.

Why is paving a driveway so expensive?

Labor. Labor also drives the cost of driveway paving since it’s a labor-intensive process. The labor cost to pave an average 450-square-foot driveway could run $5 to $7 per square foot or about $2,250. A driveway that has curves or is circular will cost more to complete, so labor costs will also increase.

How much does it cost to path a driveway?

The average costs to pave a driveway range between $3 and $15 per square foot. The cost depends on materials, size of the driveway and installation requirements….Cost to Pave Driveway Per Square Foot.

Pave Driveway Cost Per Square Foot Estimate
Average Cost $10
Highest Cost $30
Lowest Cost $2

How much does it cost to pave a driveway in BC?

A typical asphalt driveway in BC will cost around $2-$5 per square foot.

Is 2 inches of asphalt enough for a driveway?

For a regular driveway which is going to be used by regular cars, bicycles and bikes; 2 inches of asphalt is thick enough. Generally for resurfacing, 2 inches of asphalt is just about right, but if you are going for a stone surface and need a good base, it is better to layer up the asphalt thicker, around 3 inches.

Does a paved driveway add value?

Paving a new driveway can add significant value to your property. You can definitely get a great return on your investment. At the very least your property value increase will cover the cost of the driveway. The amount of added value can fluctuate.

Is it cheaper to pave or concrete a driveway?

Cost. Asphalt is generally much cheaper to install than concrete. On average, the cost per square foot for blacktop will be considerably cheaper than concrete. Maintenance costs for blacktop can be higher than a concrete driveway due to it requiring a sealant be applied more often.

Which is cheaper concrete or asphalt driveway?

Cost. The cost of an asphalt driveway is typically cheaper than concrete, costing $2.00 – $4.00 per square foot. In contrast, a concrete driveway costs between $4.00 – $6.00 per square foot for a standard installation.

Can I put asphalt over concrete?

It is safe to pave asphalt over concrete. Concrete is a great base material because it is stable and allows for excellent compaction of the asphalt above. In fact, many miles of concrete roads are paved over with asphalt every year.

How long do you stay off a newly paved driveway?

Q: How long should I stay off the new asphalt? Normally, 24-hours is all that is required to use your new asphalt surface. In very warm weather, we recommend staying off the fresh asphalt for 1 – 2 days, as the surface cools.

When should you pave your driveway?

spring
Generally speaking, late spring until early fall is the best time to pave a new asphalt driveway. This may vary depending on the region you live in. It’s best to work with asphalt when air and surface temperatures are 50°F and above. Moreover, firm ground is best for paving with asphalt.

What adds most value to a house?

What Home Improvements Add the Most Value?

  • Kitchen Improvements. If adding value to your home is the goal, the kitchen is likely the place to start.
  • Bathrooms Improvements. Updated bathrooms are key for adding value to your home.
  • Lighting Improvements.
  • Energy Efficiency Improvements.
  • Curb Appeal Improvements.