What happens if you move a washer on its side?

Laying a washer on its side can cause the inner and outer tubs to bump against each other, which can loosen support pads or damage the suspension. It can also cause the tubs to move out of alignment and alter the way your unit works.

Can I move a washing machine on its back?

Shipping your washer on its side, front, or back can damage it. When you install your washer in your new home, most likely you will have to level and balance it. Also, make sure you take out the shipping bolts before using the washer at your new location.

Can you move a washing machine without transit bolts?

Moving a washing machine without transit bolts will run the serious risk of damaging your machine, so we strongly advise against it. However, you must remember to remove the transit bolts once your move is complete, as they can seriously damage your machine should you begin a wash cycle with them still in place.

Can you move a washer and dryer on its side?

When moving a dryer: It does not harm the dryer to lay it on its side or back during transporting. Exception: Unitized washer/dryer models should only be transported / moved in an upright position. Do not lay on side or back. It’s recommended you always keep a washing machine in an upright position.

How do you move a washing machine by yourself?

How to move a washing machine by yourself: step-by-step guide

Empty your washer.
Clean the drum and drain lines.
Turn off the power.
Turn off the water supply.
Drain the water supply hoses.
Remove the water supply hoses.
Empty the drain hose.
Place the transit bolts.

Do you have to drain a washer before moving?

The drain hose is the line that carries water away from your machine. It is gray on many models, and it typically just sits loosely in a large pipe on the wall. This drain hose almost always has some water in it, so you will need to drain it before you move the washing machine or clean it.

Is it safe to move a washer and dryer?

Moving a washing machine or moving a washer and dryer combination requires preparation and planning. Washing machines need be disconnected and drained properly before a move. Washing machines can also be quite heavy. Although it is possible to move a washing machine by yourself, it’s safer and easier to get help.

What’s the best way to move a washing machine?

Wrap your washing machine in three to four moving blankets until it is completely covered and padded. Hold the blankets in place with a cord or packing tape. Next, get your helper or helpers to carefully lift your machine onto a dolly. Secure the washer to the dolly with ropes. Keep the machine upright as you wheel it through and out of the house.

What do you need to move a front loader washer?

Reference the instruction manual to learn how to keep the drum and other parts in place during a move. Top-loaders usually require you to wedge foam or cardboard between the drum and the case. For a front-loader, you’ll typically insert shipping bolts in the rear of the washer to secure the drum.

Why does my washing machine slip out of position?

During a move or DIY repair, the wash drum can slip out of position. Test the internal settings by placing a basic level on top of the washer. If the tool shows that the top section of the machine is out of balance, it’s safe to also assume that the internal drum has also moved from its original position.

Why does my washing machine keep moving around?

As mentioned earlier, the most likely reason your washing machine is shaking around so violently is that one or more of the leveling legs at the bottom of the appliance have shifted or were never correctly leveled upon installation. Try leaning against the washing machine or pushing down on opposite corners to do a quick leveling check.

Do you need to stabilize washer when moving from one home to another?

Keep the bottom styrofoam shipping base after installing the washer for future moves. If moving the washer within the home, the tub does not need to be stabilized. If moving the washer from one home to another, put the original shipping styrofoam base under unit, if available. 1995 and newer – Use a shipping rod.