How do you align the sensors on a Craftsman garage door opener?
How do you align the sensors on a Craftsman garage door opener?
You can often restore alignment without tools; simply loosen the wing nut holding the sending sensor to its galvanized steel mounting bracket and adjust its orientation until the green light on the receiving sensor glows steadily, then tighten the nut.
What does electric eye on Sears Garage door opener Do?
Sears Craftsman garage door openers have an important safety feature that prevents the door from closing when something or someone is in the way. This safety reversing sensor is actually a pair of electric eyes that generate and receive a light signal that must remain unbroken for the door to operate.
What’s the green light on the Sears Electric Eye?
The orange light on the sending sensor will remain unaffected and be glowing steadily. The green indicator light on the receiving sensor also flashes or fails to illuminate when the sensor is out of alignment with the sending sensor.
How to troubleshoot the Electric Eye in a Sears Craftsman?
To remedy this, you might have to construct a guard around the sensor to block sunlight; an empty paper towel roll works well for this. Cut about 2 inches from the end of the roll and tape it to the sensor with duct tape to restore sensor operation.
Why is my Sears eye opener not working?
Check the connection to the sensor and follow the wire all the way to the terminal on the back of the opener. You might find a staple or nail cutting through the wire insulation. Some sensors temporarily malfunction at certain times of the day, and the problem is related to the angle of the sun.
Sears Craftsman garage door openers have an important safety feature that prevents the door from closing when something or someone is in the way. This safety reversing sensor is actually a pair of electric eyes that generate and receive a light signal that must remain unbroken for the door to operate.
The orange light on the sending sensor will remain unaffected and be glowing steadily. The green indicator light on the receiving sensor also flashes or fails to illuminate when the sensor is out of alignment with the sending sensor.
To remedy this, you might have to construct a guard around the sensor to block sunlight; an empty paper towel roll works well for this. Cut about 2 inches from the end of the roll and tape it to the sensor with duct tape to restore sensor operation.
Check the connection to the sensor and follow the wire all the way to the terminal on the back of the opener. You might find a staple or nail cutting through the wire insulation. Some sensors temporarily malfunction at certain times of the day, and the problem is related to the angle of the sun.