Why is my gas meter reading blank?

If your gas meter screen is blank Your gas meter is battery powered so to save power the screen will be blank. To take a reading from your gas meter, press the round button between the two arrowed buttons and the reading will show on screen.

How do I fix my prepaid gas meter?

How to fix the meter

Put your card into the meter. It should show ‘Please wait, £XX.XX on card’
Press the red A button once to turn the meter display on.
Press the red A button again to bring up the ‘Hold for gas’ screen.
Hold down the red A button until the meter shows ‘Release A for gas’
Let go of the red A button.

What does it mean if your gas meter stops working?

Sending Unit Failure is the most-common cause of a gas gauge not working. The gas gauge might interpret voltage feedback from a dead sender as FULL or EMPTY, consequently pegging the gauge no matter the actual fuel level. Circuit Problems can cause the gas gauge to stop functioning normally.

How do you reset a prepaid meter?

Press the I key followed by 008. The consumption and number of days are displayed on the meter. The day and consumption counters will be reset by pressing the i key twice.

Who do I contact if my gas meter is not working?

If the meter is still moving, it’s probably faulty. If it’s a gas meter, you might have a gas leak – report it immediately to the National Grid Gas Emergency line on 0800 111 999. You should contact your supplier to investigate the problem with your meter. They can arrange for it to be tested.

How can you tell if your gas meter is faulty?

If the meter starts to move very quickly, the appliance could be faulty. If the meter is still moving, it’s probably faulty. If it’s a gas meter, you might have a gas leak – report it immediately to the National Grid Gas Emergency line on 0800 111 999.

How do I know if my meter is faulty?

The meter can be tested in distribution company’s laboratory or any other authorized laboratory (laboratory authorized by state electricity regulatory commission). The meter has to be tested within a few months (e.g. 2 months in Maharashtra) and the consumer can request a copy of the report of the same.

Can a gas meter reading be wrong?

Dealing with faulty gas meters High gas bills may be due to a gas meter that is incorrectly recording the amount of gas you are using, but this is unusual. While there is no simple way you can test whether your meter is accurate, if you are concerned about your meter readings, contact your energy supplier.

How do I get rid of error 30 on my prepaid meter?

Error 30 – Technical error on your meter – please switch your meter off as well as your electricity mains and wait a few minutes. Turn back on and retry the token. If this error 30 persists you should contact your municipality and get a technician to have a look at the meter.

How do you reset a meter?

The front panel of the meter has a reset button on it. If pressing the RESET button does not set all of the readings back to zero, you can hold the ENTER button and simultaneously press the RESET button.

What does my Gas prepayment meter display Tell Me?

You generally get all the information you need from nine of the available screens (see table below). To get to most screens, just press and hold the red button until you hear a beep; then keep on pressing the red button until you get to the right screen (see more below).

Why does my gas meter display stop working?

It is a smart meter that only has an A and B button and the instructions say to hold button A until the display shows the reading. Normally it would display a number of # signs and then a reading after a few seconds. Now it is just blank. The gas still seems to be flowing so I assume the display has failed.

Can a blank gas meter display show a reading?

It is the IHD (In House Display) that has its own battery, the meter itself in your photo has mains power in order to transmit its readings. You can make the IHD show a reading even if the meter screen is blank, and I am sure the right combination of buttons for a BK-G4E meter will show a reading.

How can I Turn my gas meter back on?

These steps will help you turn the meter back on. Make sure your gas appliances are turned off and that you have credit available on your gas card. Put your card into the meter. It should show ‘Please wait, £XX.XX on card’ It can take up to a minute before the meter beeps 3 times and the screen changes to ‘On’.