How do you remove the drawers from a Craftsman tool chest?

To remove drawers from a Craftsman toolbox, extend the drawer, then push a screwdriver through the slot on the right until the stop releases. Repeat on the other side. It’s best if you remove the contents first, so you don’t cause the toolbox to tip. An empty drawer is also much easier to handle.

How do you remove the drawers from a Stanley tool box?

Most Stanley toolboxes use small hand-operated levers on either side of the drawer. Extend the drawer as far as it will go, then push the levers on each side in opposite directions. This releases the drawer so you can pull it out the rest of the way. Slide the toolbox drawer all the way out.

How do you remove the drawers from a Kobalt tool chest?

Push the black release lever DOWN on the RIGHT-hand side. Pull the black release lever UP on the LEFT-hand side. While holding the levers as instructed, pull the drawer forward until released from the slides attached to the Tool Chest (“Tool Chest Slides”). Pull the drawer out so that it is almost fully extended.

How do you clean drawer sliders?

Pull the drawer out until you meet resistance.
Sweep the debris out of the drawer with a rag.
Moisten a rag with a pH-neutral household cleaner.
Wipe down both sides of the track. To clean behind the tracks, remove the screws that attach them to the cabinet or the drawer.

How do you remove a drawer from a craftsman tool chest?

Pull the drawer out of the cabinet. Press the tabs on each side with your fingers, if your drawer uses tabs instead of levers. Pull the drawer completely out of the tool chest. Kenneth Crawford is a freelance writer with more than 10 years of experience.

How do you hook up a tool chest?

Insert a flathead screwdriver into the slot, and push the inner rail stop over to the lance. Do the same thing on the other side of the drawer. Pull the drawer out of the tool chest. Angle the drawer over the two chest slides, and hook one rail into a slide.

How do you open a chest of drawers?

The drawers slide on drawer glides on each side. The drawers lock into the glides with either levers or tabs, depending upon the chest style. Open the drawer you want to remove and empty the contents. Pull the drawer out until it extends fully. Look on the side rail to see if you have a lever or tabs.

How do you remove a snap on Tool Box?

Then you need to pull the drawer from the snap on tool box as far as it extends. Start with one side of the drawer. Take a screwdriver and press the tab. Hold it like this and pull the drawer. You need to do the same with the other side of the drawer. That is how you can remove a snap on tool box drawer.

Slowly lower the other side of the drawer, and use a screwdriver to pry the stop under the outer chest slide. Push the drawer back into the tool chest. While the drawer is out of the tool chest, apply a thin coat of Vaseline to the inside rail on the drawer sides to help the drawer to continue operating smoothly.

How do you remove a tool box drawer?

Then, you take your thin piece of metal and you push this in a couple of inches till you’re past this part. Then, you pull the drawer and it will come past the catch. It is free now. Now, the other side is still attached, so I can’t take the drawer all the way out.

How do you get a dresser drawer off the rails?

Pull the drawer open until it’s as far out as possible and the guides are fully extended. 3. Check the drawer guides to see if there is a clip or locking lever. If you find a clip, remove it. If the drawer guides have a lever, push it while pulling the drawer out. 4. Continue pulling the drawer outward until it is completely off of the rails.