How do you change the belt on a Kenmore dryer Model 110?

How do you change the belt on a Kenmore dryer Model 110?

How to Change the Belt for a Kenmore Dryer Model 110

1. Unplug the power cord from the wall.
2. Open the lint filter lid on the top of the dryer.
3. Lift up the top panel.
4. Disconnect the wire harness leading to the door switch.
5. Slide the old belt off of the drum and pulleys.
6. Position the new belt around the rear pulley.

What happens when dryer belt breaks?

When Belt Breaks Over time, wear can weaken the belt until it reaches its breaking point. When a dryer belt breaks, the drum no longer turns to tumble the clothes in the dryer’s hot air. This means clothes won’t dry even if the dryer’s heater and electric motor continue to function.

How do you replace drive belt on Kenmore electric dryer?

Thread the drive belt through the idler pulley. Push the idler pulley to the right and loop the drive belt over the motor pulley. Position the front panel on the hangers at the bottom of the cabinet. Line up the mounting screw holes and reinstall the screws in the top of the front panel to secure it to the dryer cabinet.

What to do if your dryer drive belt is broken?

You can easily check whether the drive belt is broken by lifting the top and inspecting the belt. Replace a damaged or broken drive belt with the manufacturer-approved dryer part. The video below shows how to replace a broken drive belt in a gas dryer, but the repair steps are the same for electric dryers.

How do you replace the belt on a Maytag dryer?

Unplug the dryer. Pull the lint screen out of the housing in the top panel of the dryer. Use a Phillips screwdriver to remove the 2 screws that secure the lint screen housing to the top panel. Push a putty knife under the lid near the left and right edges of the front of the dryer.

Where is the drive belt on a whirlpool dryer?

Lift the front of the drum to access the drive motor and idler pulley. Thread the drive belt through the idler pulley. Push the idler pulley to the right and loop the drive belt over the motor pulley. Position the front panel on the hangers at the bottom of the cabinet.

Thread the drive belt through the idler pulley. Push the idler pulley to the right and loop the drive belt over the motor pulley. Position the front panel on the hangers at the bottom of the cabinet. Line up the mounting screw holes and reinstall the screws in the top of the front panel to secure it to the dryer cabinet.

You can easily check whether the drive belt is broken by lifting the top and inspecting the belt. Replace a damaged or broken drive belt with the manufacturer-approved dryer part. The video below shows how to replace a broken drive belt in a gas dryer, but the repair steps are the same for electric dryers.

Unplug the dryer. Pull the lint screen out of the housing in the top panel of the dryer. Use a Phillips screwdriver to remove the 2 screws that secure the lint screen housing to the top panel. Push a putty knife under the lid near the left and right edges of the front of the dryer.

Lift the front of the drum to access the drive motor and idler pulley. Thread the drive belt through the idler pulley. Push the idler pulley to the right and loop the drive belt over the motor pulley. Position the front panel on the hangers at the bottom of the cabinet.