What causes the pilot light to go out on gas logs?

If the pilot light on your gas fireplace won’t stay lit, a very likely culprit is a component called a thermocouple. The thermocouple is a metal rod that sticks out right in front of the pilot itself. It senses if flame is present or not. If the pilot light is lit, it heats up the thermocouple.

How do you light the pilot on a gas log fireplace?

How Do You Light the Pilot on a Gas-Log Fireplace? Light the pilot on a gas-log fireplace by turning the gas flow knob to the “pilot” setting, holding the knob in and using a match to ignite the pilot. After lighting the pilot, continue to hold the control knob in for about 30 seconds, or the pilot may go out.

Where is the piezo ignitor on a gas log heater?

With the control knob pushed in, push and release the piezo ignitor button to light the ODS pilot. The pilot is located on the left side of the heater, behind the middle log and on the back of the rear burner. If piezo ignitor does not light the pilot, refer to your manual for Match Lighting Instructions.

What should I do if my gas log light is not working?

Spray air around and into the end of the pilot tube opening and at the small air intake on the side of the pilot tube. If the pilot still fails, contact a qualified service technician to repair the gas log.

Can a gas log be installed in a firebox?

If you already have gas logs installed in your firebox, you can upgrade your gas log set to a more modern design, which will improve the heat and usability of your gas logs. Please note, gas appliances such as a gas log set can cause serious risk to your health and safety if not installed and maintained properly.

How to light the pilot on vent free gas log fireplace?

How To Light The Pilot On A Vent Free Gas Log Fireplace And Other Helpful Tips. Make sure your main gas supply is ON. From OFF position, turn gas control knob (reads OFF, ON & PILOT) counterclockwise to PILOT position. Push in knob (this releases the gas to the pilot area only).

Why is the pilot light on my fireplace not working?

If the pilot light does not light, several problems could be responsible. The regulator is the valve responsible for transporting gas from the building’s gas supply line to the burner inside the gas-logs. If the regulator stops working, gas cannot travel from the gas line to the pilot light.

Do you need a standing pilot light for a millivolt log burner?

Millivolt vent free log and burner sets include an oxygen depletion sensor. Be sure to check local code as not all locals allow for standing pilot lights. Millivolt ignition systems use a standing pilot light. This type of ignition system does not require any external power.