What does spa mode mean on pool heater?

water temperature setting
SPA: in this mode, the heater will automatically function to maintain the water temperature setting for SPA mode. 3. POOL: in this mode, the heater will automatically function to maintain the water temperature setting for POOL mode. Use the MODE button to change modes.

Why does my spa drain when I put it in spa mode?

Draining While the Motor IS Running The suction valves need to be adjusted properly. Turn the spa suction valve to the “off” position and make sure you have the spa return valve at least partially open. You may also want to see if the actuator has gone bad if the suction valves are fine.

Is a spillover spa heated?

Spillover spas are hot tubs that connect directly to your pool through a small curtain or fountain of water. The heated water is then pumped into the pool through the water jets.

What is spa fill mode?

Spa Fill Mode – Pool water is used to fill the spa. Sometimes referred to as spill over mode. Spa Drain – Empties the spa. The suction rate exceeds the fill rate and sends the extra water to the pool.

What does spa mode do?

During the time in “spa mode” the pool is essentially stagnant as no water is being sucked, filtered, heated or returned to the pool at all. By allowing the spa to operate isolated like this your system can now begin heating the water from 80 degrees up to 104 degrees.

Why would my spa drain?

Normally if a pool system is perfect, it’s sealed so that the water won’t drain out from the pump or anywhere else when it shuts off, but if there’s an air leak, it loses that seal and everything floods back to the pool. That’s another reason why your spa could drain out.

Why is my spa half empty?

Check for a bad seal — While PVC pipes can burst if water freezes in the line over the winter, the most likely culprit of your hot tub’s leak is a bad seal. Check pipes, elbows, unions, connections, and tees — If your hot tub is completely drained it may be difficult to locate a leak within a pipe union or connection.

How do I put my pool heater in Spa mode?

On the heater itself is the control panel and from there you can turn the heater on and set it for pool or spa mode. Once the pool pump is on you can then set the heater to the desired temperature and turn it on. If you are going to heat an attached spa, you will have to turn the valves to spa mode.

How do I get the water back into the spa?

I have 2 questions: How do I get the water back into the spa (on my … read more The water flows from my spa to pool to pump/filter and back to spa. Lately, when the pump is turned off, the water drains out from spa down to the same level as the pool.

Why is my spa draining when on Spa mode?

I drained the spa to put in fresh water. Water temp was about 54 degrees. On restart the spa went in to “watchdog” mode. How do I reset it? … read more

When did I put the Jandy system on my spa?

I have a Jandy System put in Dec 2002 where I can remote control switches to a built-in hot tub…. pool/tub combination. The hot tub runs off into the … read more I turned on the spa and heater and the spa drained? Now I turned on the spa and heater and the spa drained? Now what? … read more

I drained the spa to put in fresh water. Water temp was about 54 degrees. On restart the spa went in to “watchdog” mode. How do I reset it? … read more