Can you bend PVC trim coil?

The installation process for PVC trim is similar to the method for wood trim, including the use of the same caulk and sealants. PVC trim has the ability to bend, allowing it to be used in many types of installation situations. Homeowners can perform the bending technique easily.

How do you shape trim coils?

Trim Coil can be cut with tin snips or aviation shears for short or curved cuts. For longer straight cuts, use a utility knife to score the coil, then bend the coil back and forth on the score line until it breaks. Applying trim coil is like hanging a cover over structural piece, not laminating a skin-tight surface.

Can you use a nail gun on PVC trim?

Fasten PVC trim with stainless steel screws or hot-dipped siding nails. In areas that are completely protected from water, like under a soffit, you can use a 15-gauge air nailer with galvanized nails and fill the holes with paintable caulk or filler.

Can I bend PVC board?

PVC board bends at 200 to 250 degrees in about two minutes. Make sure you cut your vent holes after you bend it because cutting them before will not allow the plastic to distort. A router can be used to round off the edges.

What do you use bent aluminum fascia trim for?

Custom Bent Aluminum Fascia Trim is used to cover the fascia of your home. You will enjoy a lifetime of worry-free protection. Since it is maintenance-free, you can forget about peeling paint or faded colors.

How to bend coil siding without a siding brake?

Lay a piece of scrap wood on top of the metal, and clamp the scrap lumber, the metal and the bottom hinged board to the work surface. Lift the other hinged board, and apply pressure to the coiled siding with the wood. Bend in this manner until the desired angle is achieved. Bending Without a Brake; Fine Homebuilding 169; Page 52; 2005.

What kind of trim coil does Home Depot use?

Blue Red Yellow Aluminum Shop Savings 91ResultsTrim type: Trim coil Sort by:Top Sellers Top SellersMost PopularPrice Low to HighPrice High to LowTop Rated Products Get It Fast In Stock at Store Today (2) Cumberland & nearby stores Availability Hide Unavailable Products Department Building Materials Siding Siding Trim Trim type Trim coil (96)

How to make fascia trim with a hemmed bottom lip?

Here’s how to make fascia trim with a hemmed bottom lip: Step 1: Align the outside edge of the coil with the rubber strip on the moving hinge—no need to measure. Lock the coil into place and pull the handles up as far as they will go.