What is the default address for a Honeywell keypad?

The keypad’s default address is 31. Each keypad must be assigned a unique address. Keypads programmed with the same address will provide unpredictable results. To enter programming, enter the installer code (Honeywell’s factory default installer code is 4112) followed by the numbers 800.

How do I program a Honeywell 6160 keypad?

How Do I Program A Honeywell 6160 Keypad? Install a Honeywell 6160 keypad to the control panel’s keypad terminals as shown in the installation manual. Once installed, to enable the 6160 keypad, start by setting the address at the keypad. The main keypad address should be addressed to 16.

How do you change the address on an alarm keypad?

You will see the address change to (16). Then press the [*] key to confirm the address. When changing the address for a keypad that has been used before, you must simultaneously press the [1] and [3] keys for (3) seconds within (60) seconds of powering up the keypad. Again, the existing address will appear.

How many AUI keypads does Total Connect 2.0 support?

For this reason, any Vista-20P or Vista-21iP System using Total Connect 2.0 can support no more than three actual AUI keypads. Keep that in mind when planning your system. Also note that a VISTA-15P only has two available AUI addresses (1 and 2), and both are enabled by default.

How many keypads can a Honeywell Vista System handle?

How many keypads can a Honeywell Vista system handle? The Honeywell Vista systems that we sell here including the Vista 15P, Vista 20P and the Vista 21ip can accommodate up to 8 keypads. Depending on the total power that’s being drawn from the system; you may need to add an additional power supply to the system to support 8 keypads.

Can you do self-monitoring with a Honeywell Vista?

The Honeywell Vista systems such as the Vista 15P, Vista 20P and the Vista 21ip can do self-monitoring to varying degrees. We will outline below different ways this can be accomplished.

What is the best alarm keypad for a vista 20p?

The best alarm keypad for a VISTA 20P is the Honeywell 6160RF. This is an excellent keypad for arming and disarming a security system, and it allows an end user to make easy programming changes. The 6160RF also includes a built-in wireless receiver so that wireless sensors can be used.

What is compatible with a Honeywell vista-20p?

The touchscreen keypads that are compatible with the Honeywell VISTA 20P are the Honeywell Tuxedo Touch and the Honeywell 6280.Both can be used for general arming and disarming and deep level programming through Console Mode. But only the Tuxedo Touch adds Z-Wave control for the panel.. Many users want to add a touchscreen controller to their VISTA Series Systems.