How do I resync my camera?

Press the Sync button on top of the camera for about two seconds and then release the button. A blue LED on the camera blinks rapidly to confirm sync. If the LED on the camera blinks amber, the sync is not successful. You must repeat the sync process.

How do I manually sync my ultra camera?

To manually sync Arlo Ultra or Pro 3:

Release the Arlo camera from the camera housing.
Pull the camera out of the camera housing.
Press the Sync button underneath your camera.
Wait for your Arlo camera and SmartHub to sync.
Check your Arlo camera’s live stream in the Arlo app to verify that the camera was synced.

Why won’t my blink camera Connect?

Restart your device, or try switching the Wi-Fi setting off and on again to establish a connection. Make sure your mobile device is within range of your router or access point. Check that your router and any access points are powered on. Restarting your Wi-Fi router may also resolve this issue.

Where is reset button on Blink Sync module?

The reset button is located on the right-hand side of the Sync Module next to the USB port. Please note that this could take between 15-30 seconds. This will cause the Sync Module to reboot into setup mode.

Why does my Arlo cameras keep going offline?

You should also verify that the battery is charged since a dead battery obviously will make the camera go offline. One way to test is to swap batteries around. If the battery is dead, a possible reason is the WiFi quality for that camera, whether signal strength or some 2.4GHz interference (WiFi or otherwise).

What should I do if my camera won’t sync?

Your camera’s LED blinks amber if the sync is not successful. If the LED continues to blink amber and you attempted all troubleshooting options, the camera’s firmware or hardware might have an issue. For more information about troubleshooting options, see My camera will not sync with the base station; how can I troubleshoot it?.

Why is my camera not syncing with my base station?

Make sure that the camera you are trying to sync is no more than three feet away from the base station during the sync process. The sync process does not work if the camera is too far away from the base station when you press and release the Sync button.

Why is my camera not syncing with my smarthub?

The sync process does not work if the camera is too far away from the base station when you press and release the Sync button. If you’re using a single-LED SmartHub or base station, you do not need to press a Sync button. If the blue LED is blinking rapidly, your SmartHub or base station is syncing with the camera.

Why is my NVR not syncing my cameras?

My NVR is not enabled to sync but each camera is set to sync every 30 min. When I log directly into my cameras it shows that it has NTP disabled. I recheck and save and the time gets fixed. Something is disabling the checkbox on my cameras and it is loosing time.