What does Fl off mean on my pioneer receiver?

FL OFF means that your power supply circuit has failed. Unplug it for about 15 minutes, and try it again. If it goes off, disconnect the speakers from the back of the unit, make sure the volume is low, and try it again. If it fails again, it will need to go in for service.

What is Fl off?

Re: Why is there a blinking FL OFF light? Usually means the unit is locked in protect mode. Try holding the advanced surround and power buttons to see if the unit will turn on.

How to reset a pioneer receiver?

Turn on your Pioneer receiver, the button typically marked “On/Standby” or with a power icon. Hold down your receiver’s “Enter” button and the “On/Standby” button simultaneously until “Reset” and “No” appears on your display. Make the display say “Reset” and “Yes” by pressing your “Preset” arrow buttons.

Why is a red light flashing on my home audio receiver?

Here’s a link to the service manual for your receiver which should be of some help. Only p.13 section 2.2 of the manual you’ll find the flow charts for the red light protection mode. Depending on which condition is being shown the problem is either in the power amp circuit or the temperature detection circuit.

Why is my Denon home audio receiver flashing?

Denon Home Audio Video Receiver AVR391. This is an entry level home theater receiver. Why is a red light flashing? When the sound is too loud the receiver shuts off. Now a red light is flashing around the power button and the receiver will not come on. I have already tried to reset it. Answered! View the answer I have this problem too

What does red blinking power indicator avr-488 mean?

Red Blinking Power Indicator Denon Receiver AVR-488 – shuts off – won’t stay on etc.FIX! If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.

Why does my Marantz receiver have a flashing light?

The flashing light is an indication that your receivers have gone into protection mode. This can be caused by a multitude of things including speaker wire shorts and or by the receiver overheating brought about by pushing the receiver too hard or trying to drive hard to drive speakers.

Why does my Spektrum receiver flash when there is no power?

The side effect is that the LED will also flash under a few other conditions. What happens is the receiver remembers the 2 “channels” that it was using when it last had power. If that matches with the two channels that it now finds the transmitter on, it will flash thinking it had a power outage.

What does the blinking LED on my Spektrum mean?

The blinking LED was put into the latest firmware as a tool to help you diagnose a certain problem. It is there to tell you that the receiver rebooted during operation (flight). The intent was that you would look at the LED before you launch to notice that it was solid, then look at it again when it came back.