When to replace the carburetor on a Briggs and Stratton lawn mower?

This video provides step-by-step repair instructions for replacing the carburetor on a Briggs and Stratton small engine. The most common reasons for replacing the carburetor are when the engine is hard to start, stops after a few seconds, runs poorly, leaks gas, or won’t start at all. http://www.repairclinic.com/PartDetai…

How do you remove the fuel bowl from a Briggs and Stratton?

Turn the screwdriver in a counterclockwise direction. Withdraw the venturi tube from the orifice. Set it to the side. Remove the air breather from the air intake on the front side of the carburetor. A single thumbscrew holds the entire assembly to the carburetor. Locate the three screws that hold the fuel bowl to the carburetor assembly.

Is there a way to clean the inside of a carburetor?

Luckily, you can take care of many of these problems quickly and easily; often without even removing the carburetor from the engine. Commercially available carburetor cleaner comes in convenient spray cans for periodic cleaning of both inside and outside the carburetor.

Where is the model number on a Briggs and Stratton lawn mower?

If you have a push lawn mower powered by a Briggs & Stratton engine, your model number is in one of three locations. On the front of the engine directly above the spark plug. On the front of the engine between the OHV symbol and the air cleaner.

How do you fix a lawn mower carburetor?

Use a socket wrench to remove the bolt that secures the carburetor to the lawn mower. Pull the carburetor off of the throttle linkage and away from the mower. Hold the carburetor with one hand and spray it with carburetor cleaner, keeping the spray nozzle away from you while spraying.

What is a carb cleaner?

Carb cleaner is needed to clean the carburetor. This is a strong mixture of powerful chemicals which is formulated to remove dirt and other types of grime from the interior and exterior of the carburetor.

Where is the carburetor on a riding mower?

Open the hood of your riding mower and locate the carburetor adjusting screws. The carburetor is near the air cleaner assembly and the two idle adjustment screws are on the top and side of the carburetor.