What is the ground drive belt on a Craftsman riding mower?

Description: This replacement belt for the ground drive is an authentic component commonly used with Craftsman riding lawn mowers and garden tractors. It is the belt that connects the engine crankshaft pulley to the transmission pulley allowing the mower to drive.

When should I replace my drive belt?

Today, most serpentine belts are expected to last anywhere from 60,000 to 100,000 miles. Some belts can last significantly longer than this, while others give out before 60,000 miles. Make sure to check your owner’s manual to find out the recommended belt replacement time frame.

Can you replace drive belt on Craftsman riding mower?

You can use this procedure on how to replace the drive belt on a Craftsman lawn mower to replace the same part on Toro, Troybilt, Husqvarna, MTD and Ariens lawn tractors and riding mowers. If playback doesn’t begin shortly, try restarting your device.

Where is the drive belt on a riding mower?

A spacer is positioned above the pulley on the crankshaft and the top edge radius matches the step on the crankshaft. Remove the lower drive belt from the mower by pulling it towards the engine. Lawn mower belt installation is essentially the removal process in reverse.

How do you replace a blade on a riding lawn mower?

Lower the mower deck to its lowest position. Disengage the cutting blades. Roll the blade belt off the engine pulley and release the belt from the belt keepers. Remove the front lift link support retaining pin and washer and then detach the support from the deck.

What happens if the belt on a riding lawn mower breaks?

If the belt breaks, the lawn tractor won’t move. If the belt is worn, the lawn tractor moves sluggishly because the belt slips on the pulley. Examine the ground drive belt and replace it with a manufacturer-approved riding lawn mower part if it’s broken or excessively worn.

How do you replace drive belt on Craftsman riding mower?

Take front/north of belt from the far right pulley and pull to the south, then north, then south around the three middle pulleys (it will now be around four total if you count the far right pulley). Then pull the belt north to the pulley under the engine and around and out to the farthest pulley on the left.

How to change main transmission drive belt on Kohler Magnum lawn mower?

This video shows how to replace the main automatic transmission drive belt on a Sears Craftsman Kohler Magnum lawn tractor mower with an electric clutch. Model 917.256711. Please make sure you disconnect your battery and have the gas drained before flipping your mower on its side. Some motors cannot be turned on their sides.

How does a ground drive belt work on a riding mower?

This DIY riding mower repair guide gives step-by-step instructions for replacing a ground drive belt on a riding lawn mower. The ground drive belt connects the engine crankshaft to the transaxle pulley to drive the rear wheels.