What size line does a Stihl AutoCut 25 2 use?

String Diameters For example, the Stihl AutoCut 25-2 requires either a . 08-inch line or a . 095-inch line. However, each trimmer head model may vary slightly, so read the label on the package of your trimmer head.

What size line does a Stihl FSA 57 use?

It uses dual 0.065 or 0.08-inch cutting lines on a 11-inch diameter head. This Stihl 36-volt, battery string trimmer has a straight shaft and weighs 7.5 lbs.

What kind of cutting line does Stihl autocut 25-2 use?

One of these, the Autocut 25-2, spins a nylon cutting line intended for weed eating and lawn trimming. The Autocut 25-2 comes with a tapping line advance system, which advances line whenever the head is tapped against the ground. This cutting line is wound along a removable spool, which allows you to replace the cutting line whenever necessary.

How do you replace line on a Stihl string trimmer?

Please try again later. Get step-by-step instructions on replacing line in your STIHL trimmer head — right from the source. Before you begin any maintenance on your equipment, make sure the equipment is completely powered off and thoroughly cleaned of dirt and debris.

Do you need to spool a Stihl trimmer head?

For instructions on how to spool four of our most popular STIHL trimmer heads — AutoCut®, AutoCut® C (EasySpool™), STIHL FixCut™ and STIHL TrimCut™ — please click the link below. NOTE: Not all STIHL trimmer line is compatible with your STIHL trimmer head.

How do you start a Stihl FS 55 autocut?

Start the Stihl FS 55 and throttle the trigger. Hold the head one inch above the ground and tap the head against the ground to release more line from the spool. Tap the head whenever the line gets shorter than one inch; line will not advance when either side of line is less than one inches on the spool,…

How to replace trimmer line on Stihl 25-2?

To avoid this, cancel and sign in to YouTube on your computer. An error occurred while retrieving sharing information. Please try again later. Watch this short clip to learn how to replace trimmer line on a STIHL AutoCut® 25-2. You can find even more information in the Instruction Manual that comes with your STIHL cutting head.

How does a Stihl autocut 25-2 line advance system work?

The Autocut 25-2 comes with a tapping line advance system, which advances line whenever the head is tapped against the ground. This cutting line is wound along a removable spool, which allows you to replace the cutting line whenever necessary. Turn the body of the trimmer upside down so that the drive shaft is facing up.

How do you stop a Stihl fs-55 autocut 25-2?

Set the Autocut 25-2 onto the drive shaft. Turn the Autocut mowing head counterclockwise until it stops. Insert the stop pin into the hole on top of the gearbox to block the shaft. Tighten the mowing head counterclockwise. Unhook the two tabs on the head of the Autocut 25-2. Slide the spool cover off the top of the mowing head.