Why is the green light on my boiler not working?

We’ve been called out to various boilers where the green light was off, but the rest of the boiler was working correctly. There are two typical explanations for no green light being present. The most obvious explanation is the LED has failed, and needs to be replaced.

What should I do if my boiler is not working?

If Hive is connected the receiver should show: A solid green status light A solid green hot water and/or the Central Heating light If the receiver is showing solid green lights and you’re still unable to control your heating remotely there may be a fault with your boiler.

What to do if there is no blue light on a ri boiler?

If there is no blue light, there are a few explanations. Worcester suggest turning off the boiler, unplugging from the mains and then firing it back up after a few seconds. This acts as a basic reset for an RI boiler. Same as the “no green light” LED failure explanation above. Same as the “no green light” PCB failure explanation above.

What to do if there is no green light on Worcester Boiler?

Same as the “no green light” LED failure explanation above. Same as the “no green light” PCB failure explanation above. This is likely to be the case if there are no lights on your Worcester boiler. Your two options are to repair the PCB at a cost of £400+, or replace the whole appliance.

Why is the light on my Kenmore refrigerator not working?

The light assembly might be defective. Some manufacturers don’t sell the light assembly components separately, and instead require you to purchase the light assembly. The light bulb might be out.

Why is my gas boiler not working properly?

There are a variety of reasons why your boiler may not be working; common examples include the boiler pressure being too low or too high, a power cut, gas supply issues, a faulty pilot light, a frozen condensate pipe, faulty internal components or a more complex issue.

What does the green flashing light on my furnace mean?

Slow or Fast. If the green light is flashing slowly it means the furnace is on but there is no request for heat. When it is flashing fast the furnace is providing heat to the home. A continuous light means that the IFC circuit board needs replacing while a continuous off means the furnace is either off or not receiving any electrical power.

What causes the pilot light on a boiler to go out?

To ignite the gas and deliver heat and hot water, the boilers pilot light (basically a tiny internal flame) will need to be alight when your boiler is active, in order to burn the gas. Sometimes this flame will go out, whether caused by sudden drafts or wandering spirits trying to make contact.