Can you put a toilet on its side?

If you must lay the toilet on its side during this process, be very careful, as the porcelain can crack and chip quite easily. Be especially careful not to apply too much force at the point where the toilet tank is bolted to the bowl—this spot can be especially fragile.

Do you need a vent for each toilet?

Everyone knows that every toilet, bathtub, sink, shower, etc. will have a drain to carry the water away to sewage treatment, or your septic. Whether you’re putting in a tub, toilet, sink, or floor drain, they all need a plumbing vent on the drain to make it work properly.

Is there a way to install two drains in a toilet?

How to Install Two Toilet Drains. The vertical pipe that leads from a toilet to the sewer is called the soil stack. It is usually inside the wall in a position accessible to a 3-inch waste line …

How do you install a dual flush toilet?

Install the offset collar/adapter of the new toilet to the closet flange, the fitting that connects to the drain line. Put the toilet in place. Install any necessary bolts. Install the rubber gasket on the outlet of the new water tank, and insert the screws and rubber washers.

Where do you put a closet drain in a toilet?

Install closet flanges at the locations of both toilets. This is usually a matter of sawing a hole in the subfloor with a reciprocating saw, inserting the flange and screwing it to the floor. Use a 3-inch flange if the distance between the toilet and the main stack is less than 6 feet.

How do you attach a water tank to a toilet bowl?

Install the rubber gasket on the outlet of the new water tank, and insert the screws and rubber washers. Attach the tank to the bowl by sliding the screws through the holes in the back of the bowl. Add the nuts and tighten them into place.

How to Install Two Toilet Drains. The vertical pipe that leads from a toilet to the sewer is called the soil stack. It is usually inside the wall in a position accessible to a 3-inch waste line

How to install a toilet at Home Depot?

1 Place a washer and nut on each toilet bowl bolt and evenly tighten the nuts onto the bolts. 2 Alternate from one side of the toilet to the other as you tighten the nuts a little at a time. Be careful not to… 3 If the bolts extend too far over the top of the washers and nuts, cut off the excess with a hacksaw. More

Where does the toilet line go in a house?

It is usually inside the wall in a position accessible to a 3-inch waste line coming from the toilet. Most houses have more than one toilet, and if they are on the same side of the house, their waste lines can usually tie into the same stack.

Where are the vent openings for two toilets?

If they are on opposite sides, however, each may need its own stack. Since the stacks must be vented, this would mean two vent openings on the roof. Choose a location for the soil stack. If there is only one toilet, it is usually inside the wall directly behind it, but when there are two, the best place for the stack is midway between them.