How do you raise the shower drain when Retiling?

Place a piece of tile next to the original drain. Position the rubber washers on top of the original drain, stacking one washer on top of the other until you raise the drain to the same height as the tile. Make sure you take into consideration the approximate 1/8 inch of grout beneath the tile when adding the washers.

Does it matter where the shower drain is?

If the drain is in the center of the floor, you’ll have a relatively level space around the drain to stand on. However, if it’s in a corner, the entire shower floor will slope slightly in that direction. For showers that have a bench built in, placing the drain under the bench will keep it out of the way.

How high do you set the shower drain?

The top of the Pipe should be no higher than, and no more than 1/8″ lower than, the top surface of the floor on which the base will be set. Hand-tighten Drain Nut, and then tighten the rest of the way (about 1/2 turn) with a wrench.

Can a shower and tub drain be used together?

Although a shower and tub drain serve the same function — to dispose of waste water into your pipe drainage system — each one performs the task differently. A standalone shower drain and a tub or bathtub and shower combination drain cannot be used interchangeably.

What should I do if my shower wont drain?

The temperature of the water will help break up and dissolve the gunk that is blocking your drain. Attempt this only if your plumbing consists of metal pipes; don’t use boiling water if you have PVC pipes, as it could cause joints to loosen.” This next solution is a nod to that elementary school science fair classic—the volcano project.

Is there a way to offset a shower drain?

Discussion in ‘ Shower & Bathtub Forum & Blog ‘ started by Talonx13, Dec 23, 2015 . I ripped out an old shower and am installing a new one. The new drain does not match up with the existing drain pipe. The offset is minimal but enough to be a pain. This is a shower in my basement so the drain pipe goes straight into the slab.

What are the requirements for a shower drain?

Shower Drain Requirements 1 Planning a Shower Drain Location. You need a plan when you are installing a shower drain to determine where the pipe will be run, where to put the trap and 2 Drain Pipe and Trap for the Shower. 3 Vent Pipe Requirements for Showers. 4 Installing the Shower Base. …

How do you raise a shower drain after re-tiling?

Line up the holes in the universal drain extender kit with the screw holes in the original shower drain. Place the original strainer on top of the plastic ring, lining up the screw holes in the strainer with the holes in the ring. Insert the screws provided with the kit into the strainer, ring, washers and the original drain.

Why does my shower floor not drain properly?

If you use a shower pan from one manufacturer and waterproofing from another, they may not be compatible. – Double check how much waterproofing or sealing is needed. One coat may not be enough. Without the right slope on the floor of your shower, the water will not drain properly.