Does an ice maker need a drain line?

Most undercounter ice makers do require a drain line, but there are exceptions, like the EdgeStar IB120SS, that do not. These models act as a freezer and keep the ice frozen, thus no need for a drain line. Other ice makers are not able to keep the ice frozen, and as the ice melts, it needs to drain.

How do you drain an ice machine?

The ice machine’s drains can run down through the countertop and directly into the wall drain underneath the counter. These drains can be created from an existing sink drain in most locations.

Where is the drain on a Manitowoc ice machine?

NOTE: Dual evaporator models have the base drain on the right and left side of the ice machine.

What is an air gap drain?

A dishwasher air gap is a fitting mounted about two inches above the sink that prevents contaminated water from re-entering the dishwasher from the drain via backflow. An air gap is a simple way to make certain wastewater and contaminants never re-enter your clean water supply.

Do you need a gravity drain for an ice maker?

If you wish to use a gravity drain, make sure that the drain is lower than the drain outlet of the ice maker, thus the water will flow downhill, using gravity. In addition, you will need to make sure that the drain is no further than 12 inches away from the machine.

What kind of drain do I need for my undercounter ice maker?

Drain Options. Every ice maker needs a way to drain. When it comes to an undercounter ice maker, you have two drain options to choose from: gravity drains and drain pumps. If you have a drain in your kitchen within two feet of where you install your ice machine, then a gravity drain can work for you.

Do you need a drain pump for an ice maker?

A drain pump is a pump that pulls waste water away from different sources, including ice makers, and brings it to a kitchen drain. Most models of ice maker come with a drain pump installed, which makes the installation of an extra, gravity drain unnecessary.

How much drop do you need to drain an ice maker?

To properly drain the ice maker or storage bin, 1/4″ of drop is required for every 1 foot of drain line length. Let’s say you want to use an access point on one side of a room, but your ice machine is installed at a distance where the proper drain slope is not achievable. This is where a transfer drain is most useful.

Do you need a drain for an ice maker?

ICE MAKER DRAIN The ice maker can be ordered with or without a drain pump. Models without a pump will drain water by gravity. A drain must be installed. The drain and inlet water tubes must be plumbed before connection to the ice maker. For the gravity drain, horizontal drain lines must have a 1/4″(6)per 12″(305)fall.

What’s the best way to install an ice maker?

Measure the distance between your ice maker and the cold water pipe before purchasing the copper tubing to get the appropriate length. Add an extra 6–8 feet (1.8–2.4 m) of tubing to allow for cleaning and maintenance. Turn the water back on. Once you have attached the saddle valve and copper piping, you can turn your water back on.

How does an ice machine drain system work?

Commercial drain pumps work by pumping water from the ice machine to a designated access point. These pumps are the best option if you’re unable to elevate your ice machine configuration high enough to allow for a gravity-fed drain line to the drain system access point.

How tall is the drain on an ice machine?

Let our Ice Machine Experts help you choose the right ice machine for your business and install it for you. Standpipe drains are pipes that extend out of a wall or floor and run up into the air. These pipe’s dimensions can differ from 4 inches high or taller.