How do you splic a PVC drain line?
How do you splic a PVC drain line?
Put the band on the pipe sliding it up the pipe out of the way, then put the rubber in place and roll it back over itself, put the pipe in place, roll the rubber back into place over the pipe, then put the band in place and tighten it. pipes yet: Clamp and glue on saddle tees and y’s.
How do you tie PVC water line together?
Fit the “T” over the existing pipes. Press the ends of the pipe into position in the fitting and hold them together firmly for at least 30 seconds. Wipe excess glue off the outside of the new joint with a rag. Attach the new water line to the remaining opening in the “T” fitting.
How do you attach a wye to a drain line?
Push the pieces into each side of the wye and give them a quarter-turn twist. Here’s where it gets tricky—you need to prep and manage multiple glued connections in a matter of seconds. You must prime the couplings, the pipe ends of the existing drain, and the pipe ends of the new wye assembly you just made.
What’s the best way to connect a new drain pipe to an old one?
To join a new plastic drainpipe to an old steel pipe, run new pipe into the room. Prime and glue two 5-inch pieces of pipe to a tee fitting. Temporarily run pipe—longer than it needs to be—so it comes near the old pipe.
Put the band on the pipe sliding it up the pipe out of the way, then put the rubber in place and roll it back over itself, put the pipe in place, roll the rubber back into place over the pipe, then put the band in place and tighten it. pipes yet: Clamp and glue on saddle tees and y’s.
Fit the “T” over the existing pipes. Press the ends of the pipe into position in the fitting and hold them together firmly for at least 30 seconds. Wipe excess glue off the outside of the new joint with a rag. Attach the new water line to the remaining opening in the “T” fitting.
Push the pieces into each side of the wye and give them a quarter-turn twist. Here’s where it gets tricky—you need to prep and manage multiple glued connections in a matter of seconds. You must prime the couplings, the pipe ends of the existing drain, and the pipe ends of the new wye assembly you just made.
To join a new plastic drainpipe to an old steel pipe, run new pipe into the room. Prime and glue two 5-inch pieces of pipe to a tee fitting. Temporarily run pipe—longer than it needs to be—so it comes near the old pipe.