How do I reset my T Cell 15?
How do I reset my T Cell 15?
To reset, move the switch to ‘Off’ and then back to ‘Auto’. Wait for the relay to click (5 to 10 seconds). When the instant salt level is stable (and the negative sign still present), slide switch to ‘Super Chlorinate’ and back to ‘Auto’. It takes about 30 seconds for the unit to settle back on the default reading.
How do you test a 15 salt cell?
Submerge the salt cell in a bucket of pool water, but do not get the wiring connections wet. Turn on the pump and activate the salt system. Put the output on the salt system at 100% for this test. Put the output back to the original setting when you are done.
How many bags of salt do I need for my pool?
How much salt to add to the pool? To reach the initial salt level recommended by the salt system manufacturer (usually 2400-3200 ppm), you will need to add about 200 lbs of pure pool grade salt (NaCl), per 10,000 gallons of water.
Can a T 5 cell be replaced with a T 15 cell?
Basically, if you always had a T-5 cell, stay with that cell. Same goes for T-15 cell. Or you can just upgrade to a newer board. Secondly the Duty Cycle is 120 minutes in length. We will talk more about that in a second. If r1.50 or higher, you have the ability to change the cell type to T-3, T-5, T-9, or T-15.
What’s the T cell setting on Aqua rite chlorinator?
Over the years Hayward has updated the large PCB board behind the display panel. The revision starts with a lowercase “r” followed by 1.XX . See T-Cell Setting below for major differences between r1.40 and lower vs r1.50 and higher. 9. T-Cell Setting Appears only if Software revision is r1.50 or higher.
How long is the duty cycle for Aqua rite T cell 15?
For software revision 1.50 or higher the duty cycle is 180 minutes. Everything else involving output % and pump run time remains the same as well as voltage, amperage, and ISR. Save money with the CP-15 Replacement Cell for Aqua Rite T Cell 15.