How to tell if hot tub circuit board is bad?
How to tell if hot tub circuit board is bad?
You should see 220 volts. If you do not, then the circuit board is faulty and will need to be replaced or sent to us for repair. If you do see 220 volts and it is not heating then the heating element is defective and will need to be replaced.
How much does a hot tub circuit board cost?
Cost to Replace Spa Circuit Board: Hot tub PCBs range from $200-$600, with an average cost of $300.
How much is a new motherboard for a hot tub?
The national average cost range is between $160 and $400 for hot tub repair. Most homeowners spend $250 to repair a hot tub motherboard.
How many amps does Cal spa power right pump have?
The Amp rating of the pump shown is 12.0 Amps. It replaces both the 12.0 and 13.6 Amp Power Right Pumps. The pump you currently have is a 3.0 HP pump. There is not a true 6.0 HP available in the Spa Industry. Spa manufacturers (including Cal Spa) are famous for up rating the HP by just applying a sticker.
How long does it take for a hot tub pump to come on?
Make sure that a rodent has not chewed through the cable. NOTE: When you unplug the topside control from the circuit board, the low speed/filter speed should come on in approximately one minute. If it does not, then either the pump or the circuit board is faulty.
What to do if hot tub pressure switch is mis-calibrated?
If you don’t confirm water is moving in the hot tub and through the heater do not proceed with the next step as in doing so may burn out the heating element. To check to see if the pressure switch is defective or mis-calibrated, please do the following: Power down the circuit board.
What kind of circuit board do I need for a hot tub?
1. Balboa M7 Circuit Board: The reading across the two pins where both the “A” & “B” sensor plug in should read .5 volts DC. 2. Gecko Circuit Board: If you have three flashing dots on the display and there is a red light illuminated on the circuit board then the high limit sensor needs to be replaced.
How big is a Cal spa main pump?
Spa main pumps will have a size of either 48 frame, which are approx. 5.5” diameter, or 56 frame, which are approx. 6.5” diameter. Some motors will have the frame size on the unit. Plumbing size is very important, but a lot of people get it wrong and end up ordering the wrong pump.
Can a 2 speed spa pump be used?
One Speed Pump Configuration: A 2-speed spa pump can serve single-speed duty by using only the common and high speed terminal connections, while leaving the low speed terminal blank. *If your spa filtration or heating cycle comes on with high speed instead of low speed, this indicates that the high and low speed wires need to be switched.
Where can I buy a Cal spa jet insert?
We ship anywhere in the United States and Canada. Cal Spas 2 1/8 INCH CLUSTER STORM JET INSERT- STAINLESS CALPLU21703643 $0.00 2 INCH CLUSTER STORM SS JET INSERT CALPLU21703621 $0.00 2 INCH OZONE INJECTOR/CLUSTER JET CALPLU21700818 $0.00 3 INCH DIRECTIONAL STORM JET INSERT CALPLU21703432
What should the voltage be on a spa pump?
Read your spa’s owner’s manual, and look at the label on the old pump to determine the appropriate voltage and BHP (break horse power). The label on your old pump should also indicate the horsepower and amps required. Standard (US) household voltage varies between 110 and 120 volts. Larger appliances required 240 volts to function.