How do I install a new actuator?

INSTALLATION

Manually open valve.
Remove valve mechanical stops.
Check again that the valve and actuator are in the same position.
Install mounting hardware on valve, do not tighten bolts securely at this time, mount actuator to valve, and once actuator screws have been started securely tighten all nuts and bolts.

How does the Jandy valve actuator ( JVA ) work?

This video show the Jandy Valve Actuator (JVA) which works with the control systems, such as the PDA. There is also some troubleshooting included which describes how to reset the JVA after they have been disengaged for the winter. Loading…

Where is the plumbing position on a JVA?

3.1 Standard JVA Position Standard Plumbingposition is with the middle port (B) as the incoming or common port to the valve (see Figure 1). Standard Mountingposition is with the main body of the actuator over port B (see Figure 2).

Where is the toggle on 1 off on 2 switch on JVA 4?

JVA Synchronization, Toggle ON 1 OFF ON 2 On/Off Switch is located on the bottom of the JVA 4.2 Resetting the Cams WARNING Improper cam settings can result in dead heading of the water flow which can cause injury or property damage. Improper cam settings and/or operation will void the warranty.

Are there valve actuators for automatic pool systems?

Valve Actuators are designed to meet the needs of today’s more advanced, automatic pool equipment. These fully adjustable actuators offer versatile pool/spa automation with easy setups. All actuators work with AquaLink®RS Control Systems and are available in 24 volt units.

What do you need to know about a Jandy valve actuator?

DATE OF INSTALLATION INSTALLER INFORMATION INITIAL PRESSURE GAUGE READING (WITH CLEAN FILTER) PUMP MODEL HORSEPOWER FILTER MODEL SERIAL NUMBER CONTROL PANEL MODEL SERIAL NUMBER NOTES: EQUIPMENT INFORMATION RECORD Page 2ENGLISHJandy®Pro Series Valve Actuator | Installation and Operation Manual Table of Contents Section 1.

Where are the teeth on a Jandy pool Valve?

3.JVA’s mount directly on all full-size Jandy Valves Turn the actuator over so you can see into the clear actuator shaft. There are four (4) “teeth” on the inside of the shaft. Locate the smallest “tooth” and align this “tooth” with the smallest slot on the valve (see Figure 5). Figure 4. Remove Locking Knob and Lid Screws Figure 6.

How to install a JVA on a pool Valve?

Place the actuator onto the valve. 5. Rotate the actuator while keeping the two shafts engaged until the screw holes on the actuator legs align with the empty screw holes (from step 2) in the valve (see Figure 6). 6. Use the four (4) large 2″ Phillips head screws (included with the JVA) to secure the JVA to the valve. 7.