Should I leave my lazy spa heater on?

The spa can be left on, if the heater function is left on, the pump unit will maintain the temperature of the water for you. If you want to use the spa regularly this is the most cost effective way of maintaining the water temperature.

How can I Turn On my spa heater?

Turn the thermostat to the high-heat position. This should turn the spa on and send voltage to the heat relay’s control circuit. Place a voltmeter lead on the ground screw.

How do you turn on a pool heater?

On the heater itself is the control panel and from there you can turn the heater on and set it for pool or spa mode. Once the pool pump is on you can then set the heater to the desired temperature and turn it on. If you are going to heat an attached spa, you will have to turn the valves to spa mode. I go over that in detail in the video.

How to turn off heater on Sundance spa Aqua-Tech?

Activate the spa’s air blower and let it run for approximately 30 seconds.” I looked at the heater on my 2013 Sundance Optima and I don’t see any switch or plug to turn off the heater. Is it OK to turn the power breaker back on for 30 seconds with an empty tub or can you tell me how to shut off the heater?

How do you winterize a hot tub air blower?

I’m following the DIY Hot Tub Winterizing document I got from Aqua-Tech Service. One step says: “Next, locate your spa heater, and turn it off. … Activate the spa’s air blower and let it run for approximately 30 seconds.” I looked at the heater on my 2013 Sundance Optima and I don’t see any switch or plug to turn off the heater.

How do I put my pool heater in Spa mode?

How to turn on a hot tub / spa with the valves?

The last thing to remember is after going into your spa turn your valves back to where they were prior to turning on your spa/hot tub. 100% spa suction off and 80% pool to 20% spa return side. If you can imagine what the pump is doing and taking water from it is very easy for you, the homeowner, to not get confused by this process!