Why is the rollout switch open on my Raypak pool heater?

It may be a good idea to contact the installer and see if they are a warranty person for Raypak so they can diagnose what has caused the issue. Could just be high winds but it would be no cost to find out for sure. JACUSTOMER-zdajpyq1- : There is a a red plug right behind the gas pipe. I have disconnected the two plugs and reconnected them.

Is the service heater light on on my Pentair pool?

Pentair pool heater troubleshooting: service heater light is on! My pentair heater has a red “service heater” light on and the error code r13 appears when it starts up. It’s not running.

How old is Pentair Master temp pool heater?

Pentair master temp heater less than 2 years old working fine then service light came on called warranty claims and pentair sent tech out who only tested water and then said our chemicals were off – h… read more Michael Ferryman 1,336 satisfied customers Pentair swimming pool heater with error code r-13. In gound

What is the purpose of a pressure switch on a pool heater?

The purpose of the pressure switch is to ensure that water is flowing through the unit before it allows the heater to turn on. The pool pump must be ON and your filter clean for the switch to close and allow voltage to pass through.

What does hp and Hi mean on pool heater?

What it means: this code (HP & HI) indicates low water flow or high pool water temperature | HP3: 3 consecutive high-pressure faults have occurred, unit shut down Use a thermometer to check that the pool temperature matches the heater’s temperature reading

What does the Hayward pool heater error code mean?

These Hayward heat pump error code explanations will help you fix the most common Hayward pool heater problems. Need help troubleshooting or repairing your pool heater? What it means: water pressure switch detecting low water levels in the heat pump

What does LP mean on a Hayward pool heater?

Hayward heat pump error code LP | LP3 LP | LP3 What it means: something is obstructing the heat pump’s air flow | LP3 : 3 consecutive LP faults have occurred, unit shut down

How does the fault code work on a Raypak pool heater?

The majority of Raypak heaters will have a digital readout. The digital readout helps pool owners read error codes on the actual heater. The models with digital thermostats are programmed to display a variety of status and diagnostic messages, depending on the operating conditions. They are also equipped with onboard diagnostic controls.