How to convert a Balboa hot tub to a GFCI?

How to Convert From 110 Volt Plug and Play to 220/240 Volt 50 Amp GFCI TUFF SPA with BalBoa VS Pack Hot Tub…In this Video I will show you in detail Step by Step how to convert a BalBoa VS Pack from 110 volt Plug & Play to 220/240 Volt Hard wire with a GFCI.

How to convert a plug and play hot tub to a Balboa?

Tuff Spa… How to convert from 110 Volt Plug and Play Hot Tub to 220/240 Volt 50 AMP GFCI BalBoa Pack. BalBoa VS As always Thanks For watching And Please LIKE , SHARE & SUBSCRIBE ArizonaHotTub Factory.com [email protected] Tuff Spas

Why is my hot tub flashing FL-1 code?

Flashing FL-1 code and no HEAT on Jacuzzi (DIY) Step by Step how to FIX. Arizona Hot Tub Factory If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.

Why does my hot tub have low flow?

This fault has typically occurred as a result of not enough water flow through the heater to carry the hot water away from the heating element. Diagnosing the problem and fixing the cause is required, resetting the hot tub breaker will not resolve the issue. Low flow.

What does LF mean on a hot tub keypad?

LF = Persistent low flow problems. (Displays on the 5th occurrence of “HFL” message with 24 hours). Heater is shut down, but other spa functions run normally. dr = Inadequate water detected in heater. dry = Inadequate water detected in heater.

What’s the correct way to fill a hot tub?

Rule number 1 is to always (not with pressurized filter cannister) fill the hot tub after a drain down by placing the hose pipe in the filter housing (remove filter) this fills the hot tub from inside to outside, rather than placing the hose pipe in tub, (this fills outside to inside) and is the primary cause of FLO errors.

What does hi limit mean on a hot tub?

Hi limit sensor is disconnected or shorted or the spa temperature is above 112° F. SEoP = Sensor open or disconnected. Heater disabled but the spa is operational. SESH = Sensor short, nonfunctional. Heater disabled but the spa is operational. PSoC = Pressure switch open with circulating pump. PSoL = Pressure switch open with low pump.