How do you vacuum a pool with a sand filter pump?

How do you vacuum a pool with a sand filter pump?

How To Vacuum the Pool with a Sand Filter

1. Remove Large Leave or Debris.
2. Attach the Vacuum Head to the Telescopic Pole and Hose Pipe.
3. Flood the Hose Pipe With Water.
4. Attach the Hose Pipe to the Skimmer or Dedicated Suction Port.
5. Vacuum the Pool.
6. Disconnect the Hose Pipe from the Skimmer or Dedicated Suction Port.

Why is sand pumping into my pool?

Your pump may be too large or the sand level too high in the filter. When the filter is backwashing the water flow can cause the sand to rise high enough and overflow into the standpipe, which will allow the sand back into the pool.

What happens when you vacuum the sand out of a pool?

Vacuuming pool with filter valve in “backwash” position. When a pool is vacuumed with the sand filter valve in the “filter” position, the dirt and debris that passes through the pump ends up inside the filter on top of the bed of sand which is where you want it.

Can a pool pump be used to vacuum water?

Turn off the pump, remove the cartridge from its housing, and rinse/hose it off. Once cleaned, replace the cartridge, and turn the pump back on. If your pool filter system includes a multiport valve, it is possible to vacuum the pool by-passing the filter entirely and send the vacuumed water directly to the drain.

Why does my pool pump lose prime when I vacuum?

http://www.SwimmingPoolSteve.com – If your pool pump loses prime when you are manually vacuuming the pool, or when you plug in your suction based pool vac, then there are a few problems that could be potentially causing this. You first need to bleed the air from the vacuum hose before attaching it to your system.

What should the waste valve be on a pool vacuum?

That is the setting we use on our normal weekly cleaning vacuum jobs. However, when vacuuming a pool that has just had it’s mesh safety cover removed and is covered with a layer of fine dust, the multi-port valve setting should be “Waste”. This also applies to a pool covered with algae or lots of dirt.

How to vacuum an above ground pool with a sand filter?

(Playback ID: S8eqtTPzAzZhhEKi) An error occurred while retrieving sharing information. Please try again later.

How do you run a vacuum in a pool?

To run the vacuum system, you need up attach it to the skimmer inlet which is powered by the circulation pump of the pool. Remove the strainer basket. Block the open end of the hose with your hand to keep the water in. Attach the open end of the hose to the vac plate then place it in the pool skimmer.

What should the filter lever be on in a pool?

The lever should be on the ‘Filter’ setting most of the time. This is the setting that provides normal pool filtration by pushing the water through the filter media (sand, glass beads or D.E) that then traps any dirt and debris before the water is returned to the pool. This is the setting that you would use when you are vacuuming your pool as well.

Why do I need to change the valve on my pool pump?

The positions might just be numbered but usually they are marked with a single word. By changing the position of the lever on the valve you can route the water from the pump around or through your filter in different ways so that you can perform different maintenance operations on your pool water.