What does no cell power 2 mean?
What does no cell power 2 mean?
‘No Cell Power’ means the current chlorinator cycle has been interrupted due to no voltage being detected when the cell power relay was turned on. Page 3. Check System Light On: 1. No Cell Power 1 or No Cell Power 2.
When did no cell power start on Hayward AquaLogic?
In March of 2009 my Hayward Aqualogic pool system started displaying the message “No Cell Power” and the salt system in my pool was no longer working. This website details the steps involved in correcting this error.
Why does my young pool have no cell power?
Like everyone else, I had the “No Cell Power” error on my 3 year *young* system — just out of full warranty — and was slammed with the prospect of having to shell out upwards of $500-$800 to get this manufacturer’s defect fixed so my pool could be blue via the salt chlorinator again (nasty algae ensued).
Why is my salt cell saying no flow?
The system is saying NO FLOW and Chlorinator is off despite being set at 95% and super chlorinate activated – It is as if my system is not recognizing the new cell was installed. The software version is 2.6 so from what I read it sounded like I did not need to reconfigure anything.
Is the check system light on on my salt cell?
I replaced my salt cell (T-15) Hayward / Aquarite – I checked installation and my wiring etc. and all seems to be in order. My check system light is on and despite adding a lot of salt my reading is still saying very low salt and stuck at 2200 ppm.
Do you have to test the salt level in a pool?
We always recommend an independent salt level test. If the salt level is fine, inspect the Cell and clean if necessary. Never add salt without first having the water tested independent of the Aqua Rite reading. Salt only leaves the pool from backwashing a filter, splash out, leak or removing water from the pool.
How can I tell if my salt cell chlorinator is working?
A simple way to check that power is on is to feel the power cord for warmth. If the control panel has no indicator lights, that’s a good sign of no power. Check for a tripped circuit breaker or GFCI outlet test button.
How to troubleshoot problems with your salt cell?
Starting with the average salt reading. Turn the switch to ‘Off’, then back to ‘Auto’. Wait for the relay to click (about 5 to 10 seconds). Press the ‘Diagnostics’ button 5 times, this will bring up the instant salt reading.
When does the check salt and inspect cell flash?
The ‘Check Salt’ & ‘Inspect Cell’ LEDs will flash when the cell reports the salt level is between 2400 – 2700ppm. In this condition chlorine is still being produced. The ‘Check Salt’ & ‘Inspect Cell’ LEDs will be ON when the cell reports the salt level is 2300ppm or less.