Can baking soda damage a pool liner?

One of the most common ways to keep your vinyl pool liners clean is to use chemicals. NEVER add chemicals directly onto your pool liners because it will ruin your pool liner! Cleaning agents. A bleach and water solution or baking soda is a good way to clean pool liners.

Should I put baking soda in my pool?

Treating a pool requires balancing acidity and alkalinity and sustaining a pH of between 7.2 and 7.8. Along with chlorine, baking soda is an important part of your pool maintenance routine. There are many reasons to use baking soda in your pool to keep your water clean, clear, and safe for swimmers.

What causes wrinkles on a vinyl pool liner?

Low pH & Water balance – Low pH will cause a liner to develop wrinkles. When the pH drops below 7 the water becomes acidic and vinyl starts to absorb water and expand, causing wrinkles. Not enough sanitizer or too much sanitizer damages the liner.

Why do you put baking soda in your pool?

Instead, baking soda helps to maintain the pH levels of the water, which keeps a pool healthy and inviting. One of the most important ways to maintain a pool is to measure and maintain the right pH levels. If the pH levels are low, it means the water has become acidic.

Why does my pool liner keep losing water?

If you are losing water then this is a clear indication that there is a leak in the pool somewhere and this water is accumulating under the liner and causing it to float. If the pool is not losing water then the water under the liner is from a natural source such as the ground water table surrounding your pool.

What should the pH be for a vinyl pool liner?

An acidic pool will lead to your vinyl liner becoming brittle, fading in color, and eventually, falling apart entirely. Below pH neutral (7.0), pool water can become corrosive and start to eat away at your vinyl liner. As you probably already know, the ideal pH range for any pool is 7.2 to 7.6 and the same goes for vinyl-lined inground pools.

How to get rid of wrinkles in vinyl pool liner?

To get rid of the existing wrinkles, you need to use a toilet plunger. No, not the used one but a new, clean plunger, of course. The plunger will help flatten and smooth out the liner by repeatedly pressing the plunger beside the wrinkle in the direction where you want the folded liner to go (usually at the corners or sides of the floor).

What happens when you add baking soda to your pool?

Between 6 and 24 hours after you added the baking soda, retest your pool’s pH and total alkalinity. If the pH is below 7.2 and the alkalinity below 110 ppm, then repeat these steps. If you have algae in your pool, you’ll notice dull green water, slimy walls and pool bottom, and a slippery pool surface.

Why are there wrinkles on the wall of my Pool?

Wrinkles on the wall of a vinyl liner pool are usually a result of a liner that has shifted while water was under it, but has now settled since the water has receded. If this is the case it can be very hard to move the wrinkles as they will be inclined to return to their original spot.

What can I use to maintain alkalinity in my Pool?

Fortunately, there is a simple and cost-effective way to maintain your pool’s alkalinity and pH. You might use it in your cookie recipes or to freshen your fridge. This handy tool for pools is none other than Arm & Hammer baking soda, although you’ll need pounds of it rather than a pinch. What Does Baking Soda Do For a Pool?