How do you change the sand in a meteor pool filter?

Install the sand guide in the top of the filter and fill the tank about half full of water. Pour the sand into the top of the filter at a slow rate so that the weight of the sand does not damage the laterals. After the required amount of sand has been installed, remove and discard the sand guide.

What do you need to know about Triton pool filter?

Easy access, heavy-duty closure with built-in pressure relief valve makes inspection and maintenance fast and easier One-piece, fiberglass-reinforced tank with UV-resistant surface finish for years of unequaled strength and durability

When to replace a PUREX Triton FNS manifold?

Normally when a minor tear in a grid happens, It’s usually not long after that other grids begin to tear as well. Although individual grids can be purchased, It’s recommended to replace to replace the entire set. Manifold: The manifold on the top of the grid assembly directs flow through the grids.

When to backwash a PUREX Triton Nautilus FNS?

Replace the drain plug on the back of the filter. Close air relief valve. Take note of what the pressure (PSI) is after pump is running and fresh DE powder has been added. This is the “clean” filter pressure. Backwash when PSI exceeds more than 5 PSI over clean filter pressure.

Where is the split point on a PUREX Nautilus FNS?

There is an inner metal ring on the inside perimeter of the lower half of the filter, the split point. The rubber o-ring is wrapped around this metal ring. Remove both from the filter and rinse clean both the metal ring and o-ring. Rinse the split point on the filter housing of any loose debris. Line the grid assembly up correctly and replace.

How to change the base of a sand filter?

Swimming Pool filter Sand or Cartridge Spa or Pool Swimming Pool Filter Valve Gasket change Rough Base. Sand Filter re seal How to clear a Blocked pump impeller impellor. Low flow from my swimming pool or spa pump