How do you manually retract a Bigfoot leveling system?

To retract individually, press and hold the RETRACT button & the jack button. To retract all, press & hold MANUAL until light goes off, then press RETRACT. 4. When using the AUTOMATIC feature, simply press the AUTO button and then let the system operate itself.

How do you manually level an RV?

How To Manually Level Your Towable RV

Use Your Bubble Level. As you are pulling into your campsite, try to get as close as possible to being level left to right.
Go Up On Blocks. If you’re not level, grab your set of blocks.
Chock Your Wheels.
Unhitch.
Use Your Bubble Level.
Adjust the Jack.
Stabilize.

How do you level a motorhome with a hydraulic jack?

Raise the low side first: push the “up” arrow on the side that is lit up. New lights will now come on, showing that the jacks are extended. Next, level the motorhome front to rear: Raise the jacks on the low end of the motorhome until the light goes off.

What happens if your RV is not level?

If your RV is not properly level then your tank sensors will not read correctly. Depending on the slope, your sensors may read as more full or more empty than they really are. This can even affect drainage by not allowing all of your tanks to empty.

Do I need leveling blocks with auto level?

While most auto levels don’t require you to, using leveling blocks is a great way to add further stability to your RV. Most auto levels are built to carry lost of weight and support your RV, but sometimes auto levels will lift your tires off the ground.

What is the best way to level a motorhome?

In order to level your Class B or C motorhome once at a campsite, place your bubble level on a countertop to check the bubble level left to right as well as front to back. The reason for checking both straight away is because you may be able to level the RV by raising just one low corner onto blocks.

How do I reset my HWH computerized leveling system?

On the top left of your system, there should be a button labeled as ‘Auto Self-Leveling Jacks’. Open up the control panel on the system and then hold this button. You will notice that the auto-leveling system has now started to reset. Liftoff your finger and wait for this process to complete.

Are there any problems with the Bigfoot leveling system?

Problems with Bigfoot leveling system We have recently had to replace both rear tank assemblies and cylinders due to water entering the system causing the rear jacks to malfunction. Previously, Quadra personnel in Michigan drained and cleaned both reservoirs of contaminated water in the fluid.

How to troubleshoot a Quadra Bigfoot hydraulic jack?

Since each system, such as HWH, Lippert, and Quadra Bigfoot, has its own specific procedures, it is important to refer to the manual for your particular system. Don’t forget to consult your manual for additional insight into problem-solving. 4. Perform Manual Retract

Why are the leveling jacks on my RV not working?

RV Leveling Jacks Not Working: Possible Causes & Solutions If your RV leveling jacks won’t extend or retract, there could be numerous reasons. Maybe your battery is dead or can’t provide enough voltage to the equipment to work properly. Sometimes bad wiring or old wiring prevents current from reaching equipment.

What kind of leveling system does a Winnebago Brave have?

Have a 2004 Winnebago Brave with the HWH 325 series Leveling System. While driving the yellow ‘Jacks Down’ indicator light turned on and buzzer sounded, pulled over and found the LR jack was down about 1/4 inch with the round RF jack indicator on the keypad was ‘red’.

What kind of leveling system does Bigfoot use?

I have a 1998 GeorgieBoy CruiseMaster 3590 DP with the Bigfoot leveling system on it. I bought this RV about 4 months ago from the original owner. He told me he hadn’t used the jacks in years. I put on RV up on blocks, Ran all four jacks down all the way, bleed the air out of the system, and topped off the 4 separate fluid reservoirs.

How can I troubleshoot my Bigfoot coach?

Owner’s manuals and troubleshooting guide are in PDF file format, download Adobe Acrobat Reader to view. You can also use this form to message a Bigfoot Technician and have them contact you by phone or email. In most cases the coach (house) batteries do not have enough charge.

Why does my RV leveling system not work?

RV Leveling system responds to the designated built-in switch that it comes with. It may get damaged between your trips. If that’s the case you need to replace the switch as soon as possible. The leveling system will not work without the switch. Lippert Components Power Switch comes to rescue you from that hassle.