What happens if you blink on Onan generator?
What happens if you blink on Onan generator?
If you blink you may miss it. That may be a bad pun, but it is the truth when it comes to Onan generators. When something goes wrong, the generator will send out a code to tell you the problem. If you blink, you may miss the number of the error code.
What to do if your generator has a blink code?
Turn the generator off and wait for at least 2 minutes before restarting. The governor has one wire to the controller and one wire for ground. If either one is loose, that will trigger this code. All you have to do is tighten the loose wire and you should be good to go.
How to tell if Onan generator is going faster than 3, 400 rpm?
3 flashes, a pause and then one flash tells you that your Onan generator is going faster than 3,400 rpm. The trick here is to make sure you do not confuse 13 with 31. You can double-check by pressing the stop button 3 times in 5 seconds.
What happens if you run a generator with low oil?
Running your generator at low oil levels can severely damage the engine and pose a significant hazard. Before disconnecting the low oil sensor, ensure that your oil is topped off and your oil filters are not clogged.
What is the RPM of the Marquis generator?
ONAN® MARQUIS GOVERNOR TROUBLESHOOTING GUIDE. Purpose of the Governor. The purpose of a governor is to control the speed of the engine and maintain it at the proper RPM regardless of the load on the generator. This is 1800 RPM for a 60Hz output on a four-pole generator.
When did my Onan Marquis gold shut down?
I have a 2006 Weekend Warrior with a 5500 Onan Marquis Gold with 950 hours on it. I purchased the toy hauler used in 2009 and the generator did not run at all so I replaced the plugs, filters and then ultimately the entire carb. It has been running smoothly until now.
What’s the purpose of a governor on a Marquis generator?
ONAN® MARQUIS GOVERNOR TROUBLESHOOTING GUIDE. Purpose of the Governor. The purpose of a governor is to control the speed of the engine and maintain it at the proper RPM regardless of the load on the generator. This is 1800 RPM for a 60Hz output on a four-pole generator. Most small gensets use a mechanical governor to accomplish speed regulation.
If you blink you may miss it. That may be a bad pun, but it is the truth when it comes to Onan generators. When something goes wrong, the generator will send out a code to tell you the problem. If you blink, you may miss the number of the error code.
What does the code on the Onan generator mean?
When you see this code, it indicates that there is a problem somewhere on your Onan generator. You will get 3 flashes then a pause, then 3 flashes, then a pause and on it goes till you press the button to get the secondary code. The secondary code will give you the specific problem that is wrong with your generator.
What’s the problem with the Onan Cummins Generator?
Onan cummins microquiet generator has a hidden defective part. If your onan generator runs fine then stops, this is likely the free simple fix. It’s incredible how the fix is this simple. Loading…
What do I need to start my Onan generator?
Getting the Engine Running Before any evaluation of the controls, regulator or generator can proceed, the Onan engine must have oil and fuel, be in running condition and the 12-volt battery charged. The electronic governor, 151-0752, on Models BGM and NHM, Spec B and later, must be functioning properly.