What happens when you push the slide out button?
What happens when you push the slide out button?
To continue to push the in or out button for 3 to 5 seconds after the motors have stopped making noise. You can’t cause the slide out to end up on the ground if you hold your finger on the button for too long. The electronics will take care of shutting the system down once the slide out is in place.
How long to push in or out button on Jayco slide out?
Two small motors, 2 x aluminium rails a couple of gearboxes and a synchronizing electronic controller. To continue to push the in or out button for 3 to 5 seconds after the motors have stopped making noise.
Are there any problems with the slide out?
Most slide out problems are not that difficult to trace and then solve. There will be those that require the help of a professional technician to repair. The key would be to get to know your system and learn when the task is beyond your abilities to handle .
When to take your finger off the slide out button?
The trick is, once you’ve started to operate the slide out DO NOT take you finger off the button unless the slide out is either fully extended and the motors have stopped by themselves or completely retracted. If you happen to start moving the slide out then stop operating it mid operation this is how you will cause the motors to get “out of sync”.
To continue to push the in or out button for 3 to 5 seconds after the motors have stopped making noise. You can’t cause the slide out to end up on the ground if you hold your finger on the button for too long. The electronics will take care of shutting the system down once the slide out is in place.
What should I do if my slideout is not aligned?
Extend and retract the slide a few times and check for proper room flange sealing. If the room is not properly aligned, repeat steps 1 thru 6. *Depending on the size of your slide, you may need help moving the room by hand.
Most slide out problems are not that difficult to trace and then solve. There will be those that require the help of a professional technician to repair. The key would be to get to know your system and learn when the task is beyond your abilities to handle .
Two small motors, 2 x aluminium rails a couple of gearboxes and a synchronizing electronic controller. To continue to push the in or out button for 3 to 5 seconds after the motors have stopped making noise.